The objective of an effective configuration for a series of groynes in an open channel is the attainment of large bed shear stress in the main channel for channel deepening and small sidewall shear stress in the groyne fields for bank protection with the lowest cost, i.e. with the largest spacing between groynes. A Reynolds-averaged Navier–Strokes, finite-volume, numerical model was used and it was validated against experimental data for the case of a single groyne. For series of groynes with uniform spacing between them, the most effective configuration was the one with spacing equal to six groyne lengths. For the range of parameters considered, a substantial improvement of the effectiveness was achieved by implementing a novel non-uniform configuration where the spacing between groynes was reduced to one and a half groyne lengths in the first four groyne fields, and remained equal to six groyne lengths in the subsequent ones.
Freshwater resources are limited and seasonally and spatially unevenly distributed. Thus, in water resources management plans, storage reservoirs play a vital role in safeguarding drinking, irrigation, hydropower and livestock water supply. In the last decades, the dams’ negative effects, such as fragmentation of water flow and sediment transport, are considered in decision-making, for achieving an optimal balance between human needs and healthy riverine and coastal ecosystems. Currently, operation of existing reservoirs is challenged by increasing water demand, climate change effects and active storage reduction due to sediment deposition, jeopardizing their supply capacity. This paper proposes a methodological framework to reassess supply capacity and management resilience for an existing reservoir under these challenges. Future projections are derived by plausible climate scenarios and global climate models and by stochastic simulation of historic data. An alternative basic reservoir management scenario with a very low exceedance probability is derived. Excess water volumes are investigated under a probabilistic prism for enabling multiple-purpose water demands. Finally, this method is showcased to the Ladhon Reservoir (Greece). The probable total benefit from water allocated to the various water uses is estimated to assist decision makers in examining the tradeoffs between the probable additional benefit and risk of exceedance.
An economical methodology is proposed by which distinct air bubbles released at the bottom of a channel may be utilized for determining the local flow discharge q per unit width. Simple theoretical analysis shows that q is linearly dependent on the rise length L of bubbles released at the bottom. This length is the horizontal displacement of the bubbles between the release cross section and the cross section where they emerge. The theoretical findings were compared with measurements in three laboratory flumes and in an irrigation canal. Based on the above, a relationship between L and q has been established. The empirically proposed relationship is very useful for fast discharge measurements in channels and natural streams.
Reservoir design entails the determination of the required storage capacity over multiple years of low flow conditions to ensure the coverage of multiple-purpose water demands. Dam operation depends on many factors that may result in the decrease of required safe yields, leading to inadequate outflow supplies in the design period. This study addresses two issues: (a) the computation of reservoir active storage capacity performed with the aid of the new concept of a zero-height dam, a procedure easy to interpret physically and implement computationally; and (b) the generation of appropriate inflow data, provided that a substantial record of monthly inflows is available. The treatment of the inflow data for the generation of inflow sequences for any desired regulation period is performed by two original methods (First and Second), which are entirely different from other available methods and allow for the selection of a reservoir capacity with the desired level of exceedance probability. The two methods proposed give practically the same results. However, the Second Method, which generates inflow data consisting of hydrologic years with inflow values for each month randomly selected from the observed values for that month, is superior in terms of the ease with which inflow sequences are generated. Also, due to the large size of the random sample that can be generated, the exceedance probability curves are very smooth and allow for the easy selection of reservoir storage capacity with any level of desired exceedance probability. The proposed methodology may be useful for consultants and reservoir managers.