A buck-boost DC-DC converter with semi-quadratic voltage gain is introduced in this paper. The proposed converter benefits from continuous input current and common ground characteristic between input/output voltage ports. Due to low ripple input current, the proposed converter is a proper choice for carbon-free power sources such as photovoltaic (PV). Unlike the traditional buck-boost converter, the presented converter offers positive output voltage and large voltage gain without using an extreme duty cycle. Additionally, the voltage stresses across the power switches of the proposed converter are very low compared to the output voltage. Hence, power switches with low on-resistance are employed in practical implementation, which leads to power loss reduction and efficiency improvement. The performance principles, DC analysis, modelling process, and power loss analysis of the proposed converter are fully described. Finally, a laboratory prototype is implemented so as to evaluate the previously mentioned features of the proposed converter.
4 August 2021 in IEEE Transactions on Power Electronics
A new buck–boost converter with coupled inductors is presented in this article. The converter benefits from low ripple input current, simple control (both power switches operate synchronously), common ground sharing between input and output ports, low-voltage stress across the power switches, positive output voltage, and quadratic voltage gain. Since the proposed converter has continuous input current, it is a proper choice for fuel cell (FC) and photovoltaic applications. Operating principles, mathematical calculation for steady-state operation, and small-signal modeling analysis are described in detail. Finally, an experimental 25-20-200 V prototype has been implemented to confirm all the mathematical derivation and aforementioned features of the proposed buck–boost converter.
1 March 2018 in AEU - International Journal of Electronics and Communications
In this paper, an overview of several strategies for fault ride-through (FRT) capability improvement of a doubly-fed induction generator (DFIG)-based wind turbine is presented. Uncertainties and parameter variations have adverse effects on the performance of these strategies. It is desirable to use a control method that is robust to such disturbances. Auto disturbance rejection control (ADRC) is one of the most common methods for eliminating the effects of disturbances. To improve the performance of the conventional ADRC, a modified ADRC is introduced that is more robust to disturbances and offers better responses. The non-derivability of the fal function used in the conventional ADRC degrades its efficiency, so the modified ADRC uses alternative functions that are derivable at all points, i.e., the odd trigonometric and hyperbolic functions (arcsinh, arctan, and tanh). To improve the efficiency of the proposed ADRC, fuzzy logic and fractional-order functions are used simultaneously. In fuzzy fractional-order ADRC (FFOADRC), all disturbances are evaluated using a nonlinear fractional-order extended state observer (NFESO). The performance of the suggested structure is investigated in MATLAB/Simulink. The simulation results show that during disturbances such as network voltage sag/swell, using the modified ADRCs leads to smaller fluctuations in stator flux amplitude and DC-link voltage, lower variations in DFIG velocity, and lower total harmonic distortion (THD) of the stator current. This demonstrates the superiority over conventional ADRC and a proportional-integral (PI) controller. Also, by changing the crowbar resistance and using the modified ADRCs, the peak values of the waveforms (torque and currents) can be controlled at the moment of fault occurrence with no significant distortion.
8 March 2023 in International Journal of Green Energy
This paper represents a new generation of adaptive disturbance rejection control (ADRC) which is more robust against disturbances than conventional ADRC. The non-derivability of the fal function employed in the traditional ADRC has negative impacts on its operation, so alternate functions will be used which are derivable at all segments. In this regard, odd hyperbolic and trigonometric functions were employed. The performance of the proposed structure was investigated to control the doubly fed induction generator (DFIG) speed. To enhance the efficiency of the suggested ADRC, fractional-order calculations and fuzzy logic were utilized simultaneously. The results in MATLAB platform indicate that: 1) With constant wind speed and changing reference speed, using new fal functions in fuzzy fractional-order ADRC (FFOADRC) has improved the performance compared to the PI regulator and FFOADRC with default fal function. 2) During wind speed variations and using new fal functions, the DFIG speed reaches the final steady amount as over damping, while this condition is critical damping when using FFOADRC with default fal function. 3) During network voltage reduction, using new FFOADRCs leads to fewer oscillations in the stator flux, DC-bus voltage, and DFIG speed, which shows their better performance than PI regulator and traditional ADRC.
To improve the energy quality, most of the renewable energy systems and DC motor drive systems include an energy storage element charged by the bidirectional Converter. This paper propose quad quadrants dc-dc converter with high gain voltage and has a smooth output current The low current ripple and high gain features result are helpful for devices. This paper propose bidirectional DC-DC converter employs two MOSFET switch, two capacitor, two couple inductor and one small inductor, in this converter it's not necessary increase turn ratio Transformer for obtain high gain. The simulation and Theoretical analysis results match with good agreement. Simulation using MATLAB/SIMULINK.