In this paper, a new Modified Single Switch Single Ended Primary Inductor Converter (MS2-SEPIC)-based high step-up DC-DC converter is presented. The proposed topology uses the coupled-inductor (CL) technique and a voltage tripler rectifier which result a high voltage gain for the converter. Here, the switching loss has been reduced significantly because of the owing to the quasi-resonance operation of the circuit created by the leakage inductance of the CL along with circuit capacitors. The operational principles and steady state analysis are discussed. Experimental results based on a 100W laboratory prototype verify the validity of theoretical analysis.
30 March 2021 in IEEE Journal of Emerging and Selected Topics in Power Electronics
A buck-boost DC-DC converter with semi-quadratic voltage gain is introduced in this paper. The proposed converter benefits from continuous input current and common ground characteristic between input/output voltage ports. Due to low ripple input current, the proposed converter is a proper choice for carbon-free power sources such as photovoltaic (PV). Unlike the traditional buck-boost converter, the presented converter offers positive output voltage and large voltage gain without using an extreme duty cycle. Additionally, the voltage stresses across the power switches of the proposed converter are very low compared to the output voltage. Hence, power switches with low on-resistance are employed in practical implementation, which leads to power loss reduction and efficiency improvement. The performance principles, DC analysis, modelling process, and power loss analysis of the proposed converter are fully described. Finally, a laboratory prototype is implemented so as to evaluate the previously mentioned features of the proposed converter.
25 December 2019 in IEEE Transactions on Power Electronics
A New Coupled-Inductor Buck-Boost Converter (CIBuBoC) is proposed in this paper. In the proposed CIBuBoC, an ultra-high step-up/step-down voltage conversion ratio and step-up/step-down boundary adjustment are achieved compared to the other related buck-boost converters using two power switches with simultaneous operation along with a coupled-inductor. This circuit has a simple structure with two cascade semi-stage and some features including ultra-extended output voltage, continuous input current with low ripple, the positive polarity of the output voltage and common ground. These features make the CIBuBoC more suitable for many applications such as photovoltaic (PV) systems. Moreover, the voltage stress across each power switches is much lower than the other buck-boost converters led to power MOSFETs selection with lower drain-source ON resistance (Rds). Therefore, the proposed converter has also enough high efficiency. All steady-state and stress analysis and also comparisons with other related converters in Continuous Conduction Mode (CCM) are provided in detail. Also, using the state-space averaging technique, the low-frequency behavior of the proposed CIBuBoC is studied completely. Experimental results of a 100W step-up 30V-200V and a 35W step-down 30V-22V confirm the theoretical advantages of the proposed circuit.
4 August 2021 in IEEE Transactions on Power Electronics
A new buck–boost converter with coupled inductors is presented in this article. The converter benefits from low ripple input current, simple control (both power switches operate synchronously), common ground sharing between input and output ports, low-voltage stress across the power switches, positive output voltage, and quadratic voltage gain. Since the proposed converter has continuous input current, it is a proper choice for fuel cell (FC) and photovoltaic applications. Operating principles, mathematical calculation for steady-state operation, and small-signal modeling analysis are described in detail. Finally, an experimental 25-20-200 V prototype has been implemented to confirm all the mathematical derivation and aforementioned features of the proposed buck–boost converter.