Electrostriction is an intriguing behaviour of dielectric materials, characterized by stable electrostrain with minimal hysteresis. (Na0.5Bi0.5)TiO3-based ceramics show promising electrostrictive behaviour, particularly the 0.90(Na0.5Bi0.5)TiO3-0.08KNbO3-0.02SrTiO3 composition located near the morphotropic phase boundary between ferroelectric rhombohedral and relaxor pseudocubic phases. The templated grain growth method has been effectively used to control the grain orientation of NBT-based systems, thereby enhancing their electrical properties. In this study, texturing was introduced to 0.90(Na0.5Bi0.5)TiO3-0.08KNbO3-0.02SrTiO3 ceramics through homoepitaxial NBT platelets prepared via a three-step molten salt/topochemical microcrystal conversion method. By adding 4 wt% of NBT platelets combined with optimized sintering conditions, textured ceramics were prepared exhibiting a high Lotgering factor of 83% with enhancement of strain (0.02%) and polarization (3 µC/cm2) at an electric field of 40 kV/cm, as well as stable dielectric permittivity between 130 and 300 °C. Moreover, the electrostrictive coefficient of textured ceramics increased by ~0.004 C2m−4 compared to that of untextured ceramics, confirming the improvement of the electrostrictive response. These results demonstrate that homoepitaxial templating effectively improves the electrical properties of NBT-KN-ST ceramics while preserving their electrostrictive nature, which offers a viable route for designing lead-free electrostrictive materials.
Cuprous oxide (Cu2O) thin film was decorated with copper metal (Cu) by the simple electrochemical deposition method. This study was motivated to improve the role of Cu as a co-catalyst due to the narrow band gap energy of known photocatalyst Cu2O. Cu was electrodeposited on Cu2O thin film with a substrate of indium tin oxide (ITO) at a voltage of -0.3V and a temperature of 60 °C in CuSO4 (pH 10) under a magnetic stirrer. The structure, phase, and morphology of Cu2O/Cu were characterised by X-ray diffraction, scanning electron microscopy, and energy-dispersive X-ray spectroscopy. The electrocatalytic performance of Cu2O/Cu was recorded using linear sweep voltammetry and electrochemical impedance spectroscopy. XRD and SEM results show Cu was successfully deposited covering Cu2O. The current density of Cu2O/Cu increased by 2.7041 mA/cm2 confirming the lower charge current resistance of 2.48 kΩ. The Cu-decorated Cu2O demonstrated an improved photocatalytic activity, as shown by the increase of MB degradation from 46.33% to 50.87%. It was believed from characterisations that Cu deposition leads to more dense carriers and charge transfer, hence higher photocatalytic activity towards MB degradation than bare Cu2O thin film.
The FeCo thin films were synthesized using a potentiostatic electrodeposition technique under varying deposition temperatures and saccharin compositions. The effects of these parameters on the film’s crystallinity, composition, microstructure, and deposition behavior were systematically investigated. X-ray diffraction confirmed the formation of a single-phase FeCo structure under all conditions. Increasing the deposition temperature enhanced mass transfer and reduced anomalous codeposition behavior, as evidenced by the compositional shift toward higher cobalt content. The presence of saccharin was found to significantly influence the nucleation and growth processes through adsorption and the formation of metal–saccharinate complexes, which altered the deposition behavior. These results demonstrate that optimizing deposition parameters enables precise control over the composition and structure of FeCo thin films, which is crucial for the functional applications of magnetic and electrocatalysis.