Anthropogenic 129I as a long-lived radioisotope of iodine has been considered as an ideal oceanographic tracer due to its high residence time and conservative property in the ocean. Surface water samples collected from the East China Sea (ECS) in August 2013 were analyzed for 129I, 127I and their inorganic chemical species in the first time. The measured 129I/127I ratio is 1–3 orders of magnitude higher than the pre-nuclear level, indicating its dominantly anthropogenic sources. Relatively high 129I levels were observed in the Yangtze River and its estuary, as well as in the southern Yellow Sea, and 129I level in seawater declines towards the ECS shelf. In the open sea, 129I and 127I in surface water exists mainly as iodate, while in Yangtze River estuary and some locations, iodide is dominated. The results indicate that the Fukushima nuclear accident has no detectable effects in the ECS until August 2013. The obtained results are used for investigation of interaction of various water masses and water circulation in the ECS, as well as the marine environment in this region. Meanwhile this work provides essential data for evaluation of the possible influence of the increasing NPPs along the coast of the ECS in the future.
31 January 2019 in Journal of Physics D: Applied Physics
Multi-main-phase (MMP) (Nd, Ce) 2 Fe 14 B magnets containing both Nd-rich shell covering Ce-rich core and Ce-rich shell covering Nd-rich core within the 2:14:1 grains have shown much superior coercivity to the single-main-phase ones with homogeneous Nd/Ce distributions. To understand how these core–shell grains and the microstructure of grain boundaries (GBs) influence the coercivity of MMP Nd–Ce–Fe–B magnets, micromagnetic simulation was carried out through constructing a 3D finite element model. The influences of physical dimension and magnetism of the GBs, Nd or Ce-rich shell thickness, and Ce substitution level on coercivity were all analyzed. It was found that thick and nonmagnetic GB layers play an essential role in enhancing the coercivity as the intergrain exchange coupling can be weakened. Thicker Nd-rich or Ce-rich 2:14:1 grain shells are not necessary for enhancing the coercivity. In addition, with the increase of Ce content, the coercivity does not deteriorate linearly but exhibits an abnormal enhancement around 20 vol.% substitution. The good agreement with the experiments makes these findings as important insights of understanding the coercivity mechanism of MMP RE–Fe–B magnets.
Pelleting is the most extensively used thermal processing method in feed industry. In this article, a single pellet press device was developed to investigate the pelleting processing of animal feed. Effects of moisture content (10%-18% w.b.), preheating temperature (60°C-100°C) and maximum compression force (0.2-0.6 kN) on feed pellet were determined and analyzed, as well as energy consumption. The results showed that unit density, pellet hardness and energy consumption were 0.87-2.92 g/cm3, 1.08-4.55 kg, and 3.27-12.66 J/g, respectively. Unit density was found to increase with the increase of preheating temperature and maximum compression force, but decrease with the increase of moisture content. Pellet hardness showed a first ascending then descending trend with the increase of moisture content, but exhibited a positive relationship with both preheating temperature and maximum compression force. Energy consumption increased with the increase of maximum compression force, but exhibited descending trends with the increase of moisture content and preheating temperature. Due to its features of low cost, high efficiency and easy control, the single pellet press device has a wide application prospect in feed processing. Keywords: feed, pelleting, energy consumption, preheating temperature, experiments DOI: 10.25165/j.ijabe.20221504.6155 Citation: Peng F, Xiang R, Fang F, Liu D. Analysis of feed pelleting characteristics based on a single pellet press device. Int J Agric & Biol Eng, 2022; 15(4): 65–70.