Zixuan Mu

Zixuan Mu


Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
Verified
Journal Article
Open access
PDF file
ASAbhishek Singh
Abhishek Singh
LWLuohaoran Wang
Luohaoran Wang
ZMZixuan Mu
Zixuan Mu
MBMihaela Banu
Mihaela Banu
Material Extrusion (MEX)-based Additive Manufacturing (AM), particularly metal Fused Filament Fabrication (FFF), has gained attention for fabricating metal components due to its operational simplicity, cost-effectiveness, design flexibility, and reduced material waste. Compared with laser powder bed fusion, metal FFF offers lower thermally induced residual stress and avoids direct powder handling. However, dimensional accuracy and surface quality remain affected by process variability, shrinkage during sintering, and geometry-dependent material redistribution. Quantitative relationships among geometric features, dimensional deviation, and surface morphology are still limited. This study investigates geometry-dependent dimensional and surface variability in metal FFF parts using two stress-concentrator geometries: a plate with a circular hole and a specimen with a filleted transition. Geometric features, including hole diameter, fillet radius, and local curvature, were evaluated in relation to dimensional variability and surface roughness. The analysis used RMS-based dimensional error, PCA-based roughness indexing, regression, and clustering. The results showed that hole specimens had lower dimensional behavior, with ΔRMS values ranging from approximately 0.790% to 1.606%, whereas fillet specimens exhibited higher variability, with ΔRMS values ranging from 1.140% to 4.086%. Sensitivity analysis showed that the higher variability of the fillet geometry was primarily associated with the local curved transition rather than the specimen’s global dimensions. Regression indicated that surface roughness alone did not explain dimensional variability, while tensile strength provided an additional performance descriptor. Clustering further showed more compact response groupings for the hole specimens and more dispersed groupings for the fillet specimens, indicating the greater geometry sensitivity of the filleted transition. By combining the parameters studied, a framework was developed to provide a quantitative basis for assessing geometry-dependent variability and to support improved design guidelines for metal FFF parts with filleted transitions and stress-concentrating features.

16 April 2026 in Solid State Phenomena
Verified
Journal Article
Open access
PDF file
ZMZixuan Mu
Zixuan Mu
YLYoungrok Lee
Youngrok Lee
JAJeffrey Abell
Jeffrey Abell
ATAlan Taub
Alan Taub
MBMihaela Banu
Mihaela Banu
Geometric deviations remain a major barrier to the widespread industrial adoption of incremental sheet forming (ISF). Compared with conventional toolpath compensation that rely on extensive data generation and trial-and-error procedures, variation of toolpath styles offers a more direct and efficient strategy for mitigating geometric defects. In this study, multiple curvilinear toolpath strategies were investigated for a standard closed-contour ISF part to evaluate their effectiveness in reducing geometric deviations. Six toolpaths were examined, including three established types – convex, concave, and wavy – and three novel toolpaths proposed in this work: adaptive, cusp, and sine. The convex toolpath achieved the largest side-wall springback reduction relative to the linear baseline but introduced a significant bottom pillow effect and reduced formability. While the cusp toolpath effectively suppressed both springback and pillow formation, it resulted in local thickening and degraded surface finish. Overall, the sine toolpath provided the most balanced performance, achieving effective reduction of all major geometric defects. Numerical simulations reveal an inherent tradeoff between side-wall springback reduction and bottom pillow formation, as positive residual bending moments formed in the pillow region contribute to springback mitigation by promoting outward bending of the side walls.