Due to the development of thin slab hot rolling technology, hot rolling thin strip at a higher speed is inevitable. As a result of high-speed rolling, thin slab is deformed at a wide range of strain rate inside the rolling zone. Because the flow stress of steel is strongly dependent on strain rate at elevated temperature, it is imperative to consider its variation when calculating roll force and roll pressure. By substituting time with speed and length, strain rate variation is obtained. A strain rate–dependent flow stress curve for non-oriented silicon steel is implemented into Karman equation to calculate rolling pressure distribution. It is revealed that the rolling force can be effectively reduced by decreasing the radius of work roll. It is further revealed that the appearance of strip/roll surface sticking is more likely at the exit of rolling zone than the neutral point, because strain rate reaches zero and the flow stress drops at the exit. Combined with Influence Function Method for elastic deformation of roll surface, the proposed model can predict roll force with a good accuracy compared with industrial data.
International audienceThe present paper focuses on the validation of ongoing efforts made to develop more advanced 3D mathematical model for cold rolling strip process [8]. Following [2], the model uses the multi-slab strategy to deal with the differential reduction in the transverse direction due to roll deformation, and analytical solutions of roll bending and flattening discretized by the Influence Function Method (IFM). Furthermore, the model has been extended to incorporate elastic deformation of strip and to be fit for 6-high rolling mills with shiftable work roll (WR) or Intermediate Rolls (IR) as well as 4-high mills. Validation is performed by using FEM solutions (Abaqus® implicit) as references: a 2D quasi-static model to check the slab method under rigid work roll condition; a 3D FEM to discuss the assumption of small lateral flow of strip; a comparison of FEM and IFM with regard to 6-high roller stack deformation with intermediate roll shifting. All these steps are essential to gain more insight into the mechanism of cold rolling strip and to guide future development work of the mathematical model. Abstract The present paper focuses on the validation of ongoing efforts made to develop more advanced 3D mathematical model for cold rolling strip process [8]. Following [2], the model uses the multi-slab strategy to deal with the differential reduction in the transverse direction due to roll deformation, and analytical solutions of roll bending and flattening discretized by the Influence Function Method (IFM). Furthermore, the model has been extended to incorporate elastic deformation of strip and to be fit for 6-high rolling mills with shiftable work roll (WR) or Intermediate Rolls (IR) as well as 4-high mills. Validation is performed by using FEM solutions (Abaqus® implicit) as references: a 2D quasi-static model to check the slab method under rigid work roll condition; a 3D FEM to discuss the assumption of small lateral flow of strip; a comparison of FEM and IFM with regard to 6-high roller stack deformation with intermediate roll shifting. All these steps are essential to gain more insight into the mechanism of cold rolling strip and to guide future development work of the mathematical model
1 January 2019 in Journal of Mechanical Engineering
In order to produce a thin non-oriental silicon steel strip with high surface quality, the hot rolled strip needs to undertake a large reduction by cold tandem rolling process. As a result of thin strip rolling, the rolling pressure is concentrated on a small area of the work roll surface causing a large elastic deformation. Because of the transverse thickness distribution of strip is strongly dependent of roll’s shape, it is imperative to consider work roll’s non-circular shape. By relaxing the Hitchcock assumption, vertical displacement of work roll surface is calculated in both rolling and transverse direction. By assuming the thickness of strip does not increase when rolled, a Slab method is implemented to calculate roll pressure due to work roll’s shape. Combined with Influence Function Method for loads distribution between stacked rolls, the proposed model can predict thin strip transverse thickness profile with a good accuracy compared with industrial data under varied conditions. Five-pass cold reversal rolling process is investigated by the validated model. It is revealed that the transverse thickness deviation can be effectively reduced by decreasing the entry thickness of strip.