Small-scale electrical power generation (<100 kW) from biogas plants to provide off-grid electricity is of growing interest. Currently, gas engines are used to meet this demand. Alternatively, more efficient small-scale solid oxide fuel cells (SOFCs) can be used to enhance electricity generation from small-scale biogas plants. Most electricity generators require a constant gas supply and high gas quality in terms of absence of impurities like H2S. Therefore, to efficiently use the biogas from existing decentralized anaerobic digesters for electricity production, higher quality and stable biogas flow must be guaranteed. The installation of a biogas upgrading and buffer system could be considered; however, the cost implication could be high at a small scale as compared to locally available alternatives such as co-digestion and improved digester operation. Therefore, this study initially describes relevant literature related to feedstock pre-treatment, co-digestion and user operational practices of small-scale digesters, which theoretically could lead to major improvements of anaerobic digestion process efficiency. The theoretical preamble is then coupled to the results of a field study, which demonstrated that many locally available resources and user practices constitute frugal innovations with potential to improve biogas quality and digester performance in off-grid settings.
A small-scale (up to 5 kWe) biogas-solid oxide fuel cell (SOFC) energy system is an envisioned system, which can be used to meet both electrical and thermal energy demand of off-grid settlements. SOFC systems are reported to be more efficient than alternatives like internal combustion engines (ICE). In addition to energy recovery, implementation of biogas-SOFC systems can enhance sanitation among these settlements. However, the capital investment costs and the operation and maintenance costs of a biogas-SOFC energy system are currently higher than the existing alternatives. From previous works, H2S removal by biochar was proposed as a potential local cost-effective alternative. This research demonstrates the techno-economic potential of locally produced biochars made from cow manure, jackfruit leaves, and jack fruit branches in rural Uganda for purifying the biogas prior to SOFC use. Results revealed that the use of biochar from cow manure and jack fruit leaves can reduce H2S to below the desired 1 ppm and substitute alternative biogas treatments like activated carbon. These experimental results were then translated to demonstrate how this biochar would improve the economic feasibility for the implementation of biogas-SOFC systems. It is likely that the operation and maintenance cost of a biogas-SOFC energy system can in the long run be reduced by over 80%. Also, the use of internal reforming as opposed to external reforming can greatly reduce the system capital cost by over 25% and hence further increase the chances of system economic feasibility. By applying the proposed cost reduction strategies coupled with subsidies such as tax reduction or exemption, the biogas-SOFC energy system could become economically competitive with the already existing technologies for off-grid electricity generation, like solar photovoltaic systems.
Dry reforming of methane (DRM) is an attractive route for H2 production and simultaneous CO₂ utilization, but its practical implementation is limited by catalyst deactivation. This study experimentally investigates the catalytic performance of Ni/Al₂O₃ and Gd-doped ceria–promoted Ni/GDC–Al₂O₃ catalysts for DRM in a fixed-bed quartz reactor over 400–800 °C at gas residence times of 0.1 s and 0.4 s. Increasing temperature and residence time enhanced CH₄ and CO₂ conversion as well as H₂ and CO yields for both catalysts. The GDC-promoted catalyst exhibited markedly improved activity, achieving conversions and product yields at 0.1 s comparable to those of Ni/Al₂O₃ at 0.4 s and reaching complete CH₄ conversion at about 650 °C, approximately 100 °C lower than the Ni/Al₂O₃. Long-term testing demonstrated high durability of Ni/GDC–Al₂O₃ at 650 °C with no detectable carbon deposition, consistent with thermodynamic equilibrium analysis.
Dry reforming of methane (DRM) is an attractive route for H2 production and simultaneous CO2 utilization, but its practical implementation is limited by catalyst deactivation. This study experimentally investigates the catalytic performance of Ni/Al2O3 and Gd-doped ceria-promoted Ni/GDC–Al2O3 catalysts for DRM in a fixed-bed quartz reactor over 400–800 °C at gas residence times of 0.1 s and 0.4 s. Increasing temperature and residence time enhanced CH4 and CO2 conversion as well as H2 and CO yields for both catalysts. The GDC-promoted catalyst exhibited markedly improved activity, achieving conversions and product yields at 0.1 s comparable to those of Ni/Al2O3 at 0.4 s and reaching complete CH4 conversion at about 650 °C, approximately 100 °C lower than the Ni/Al2O3 catalyst. Long-term testing at 650 °C showed stable catalytic behavior of the Ni/GDC–Al2O3 catalyst, while operational observations qualitatively suggested the absence of significant carbon deposition, consistent with equilibrium calculations.