JunHao Hu

Mr. JunHao Hu


Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 November 2026 in Processes
Verified
Journal Article
Open access
PDF file
TGTao Gong
Tao Gong
JLJiahao Liu
Jiahao Liu
MZMing Zhao
Ming Zhao
LJLIU Jin-gang
LIU Jin-gang
XZXuan Zhou
Xuan Zhou
JHJunHao Hu
JunHao Hu
Diamond particles tend to disperse non-uniformly during the electroplating sand-setting process of diamond wire manufacture. To address this problem, the gas–liquid–solid three-phase flow characteristics in a baffled semi-circular reciprocating mixing tank were numerically analyzed by means of CFD(computational fluid dynamics). A VOF–DPM (Volume of Fluid–Discrete Phase Model) coupled gas–liquid–solid model was established to investigate the flow-field evolution within a stirring cycle, the velocity distribution characteristics, and the influence of the reciprocating frequency on mixing performance; the particle mixing uniformity of the reciprocating stirring device was further verified by sampling experiments. The results show that three typical dynamic vortex regions are formed in the tank, located above and below the stirring plate and outside the baffle, and the flow structure evolves periodically with the motion of the stirring plate. The reciprocating motion of the flat plate exerts a pronounced velocity-amplification effect on the fluid: the maximum axial velocity in the tank can reach 1.95 times the maximum velocity of the stirring plate. Increasing the reciprocating frequency raises the overall flow velocity and improves the uniformity of the velocity distribution, but does not change the basic flow pattern. Under the process condition of 0.5 Hz, which was evaluated experimentally by multi-point sampling (the CFD simulations were performed at 0.25, 0.62, and 1.00 Hz), the relative standard deviation of the diamond particle mass fraction is 4.62%, satisfying the requirements of the diamond wire electroplating sand-setting process. The results provide a theoretical basis for the structural optimization and process parameter regulation of reciprocating stirring devices for diamond wire sand-setting.

13 October 2026 in Metals
Verified
Journal Article
Open access
PDF file
TGTao Gong
Tao Gong
JLJiahao Liu
Jiahao Liu
LJLIU Jin-gang
LIU Jin-gang
JHJunHao Hu
JunHao Hu
ZLZhuangzhi Li
Zhuangzhi Li
MZMing Zhao
Ming Zhao
For coarse-diameter electroplated diamond wires, the traditional horizontal sanding process suffers from inhomogeneous circumferential abrasive distribution, a lengthy manufacturing process, and poor production consistency. To address these issues, a pre-plating-free one-step electroplating process based on rotating magnetic field-assisted vertical sanding is proposed. Through the construction of a high-precision multi-process cooperative control system based on a dual-PLC architecture, systematic optimization of the process parameters from pre-treatment and electrodeposition to post-treatment is realized. Combined with the magnetohydrodynamic (MHD) and electrodeposition kinetic theories, the regulation mechanism of the rotating magnetic field-induced micro-convection effect on the mass transfer of the plating bath, particle dispersion, and grain refinement is revealed, and the kinetic principle by which the bottom-to-top vertical wire-running mode improves the circumferential deposition uniformity of abrasive grains on coarse-diameter wires is clarified. The experimental results show that the breaking force and the number of torsion cycles of the prepared diamond wire under the optimized process conditions are increased by 14.33% and 175.80%, respectively, and the properties of the head and tail ends of the wire exhibit high consistency. This study provides theoretical support for the industrial production of high-quality, high-consistency coarse-diameter diamond wires.