This study explored the effect of incorporating cellulose and starch nanoparticles, obtained from the Commelina coelestis Willd plant, on the physical and chemical properties of starch-based films derived from the same plant. Additionally, the synergistic effect of combining the nanostructures was assessed. The nanocomposite biopolymer films were prepared by the casting method using 1 and 3 wt% concentrations of the nanostructures (CNCs: cellulose nanocrystals, CNFs: cellulose nanofibers, SNCs: starch nanocrystals), or their blend. The physicochemical (swelling capacity and water solubility), morphological (SEM and AFM), thermal (DSC and TGA), and mechanical properties (tensile strength, elongation at break, and Young’s modulus) of the films were evaluated. The nanocomposite biopolymer films exhibited better dimensional stability (40–60%) than the control films. Tensile strength (8–300%) and Young’s modulus (15–690%) were improved. Moreover, these films displayed enhanced thermal stability, withstanding temperatures exceeding 305 °C. FTIR spectra evidenced intermolecular interaction among the matrix and nanostructures. Microscopic analyses further supported the integrity of the films, which displayed a homogeneous surface and the absence of fractures. In addition, the nanocomposite biopolymer films prepared with 1 wt% cellulose nanocrystals and nanofibers had a lower opacity than those with a higher percentage (3 wt%). Overall, our findings suggest that the Commelina coelestis Willd is a promising starch source that can be used to obtain nanocomposite biopolymer films as an alternative to produce novel, efficient, and eco-friendly materials with adequate thermo-mechanical properties intended to replace conventional plastic materials in single-use applications such as those used in the food packaging industry.
17 July 2024 in Journal of Vacuum Science & Technology A
In this study, novel findings were obtained regarding the influence of a 10 A current intensity on the growth of an FeB–Fe2B layer during pulsed-DC powder-pack boriding. Boride layer formation was carried out on AISI 316 L steel at 1123–1223 K for different exposure times at each temperature, considering 10 s polarity inversion cycles. The boride layer was characterized by x-ray diffraction and high-speed Berkovich nanoindentation, the latter being used to determine the hardness and reduced Young’s modulus mappings along the depth of the layer-substrate system. Moreover, the growth kinetics of the FeB–Fe2B layer on the steel’s surface was modeled using the heat balance integral method (HBIM). This involved transforming Fick’s second law into ordinary differential equations over time, assuming a quadratic boron concentration profile in space to determine the B diffusion coefficients in FeB and Fe2B, respectively. From the Arrhenius relationship, the B activation energies in the boride layer were estimated considering the contribution of the electromigration effect; the results showed an approximately 30% reduction compared to the values obtained in the conventional powder-pack boriding for AISI 316 L steel. Finally, the theoretical layer thickness obtained by the HBIM demonstrated an error of no more than 5% against the experimental FeB and FeB + Fe2B layer thickness values.
1 January 2022 in Plant Physiology and Biochemistry