Acoustic logging tools, deployed thousands of meters underground to detect geological structures and evaluate reservoir fluids, are essential for oil and gas exploration and development. These tools generate acoustic signals through piezoelectric ceramic transducers. The material properties of piezoelectric ceramics are significantly affected by the high-temperature downhole environment, leading to a failure in impedance matching between the transducer and its excitation circuit. This results in a substantial degradation of the tool’s performance. This paper experimentally obtains the electrical parameters and excitation energy of commonly used monopole transducers at different temperatures. Based on this data, the optimal matching inductance values at various temperatures are calculated. A temperature-adaptive transducer excitation circuit is then designed and implemented. This circuit can adjust the excitation frequency according to the measured temperature to compensate for resonant frequency drift and select the optimal inductor tap via a programmable multiplexer. Experimental results demonstrate that this circuit significantly enhances the transducer’s excitation energy at high temperatures. This technology is expected to markedly improve the operational stability of acoustic logging tools and facilitate the exploration and development of deep and ultra-deep oil and gas resources.
Piezoelectric acoustic logging transmitters are commonly evaluated using low-voltage small-signal impedance measurements, whereas their practical operation involves high-voltage, high-current, finite-cycle short-burst excitation. This difference makes it difficult to predict the actual loaded electrical input state and directional acoustic response from conventional impedance spectra alone. In this study, a high-voltage short-burst electroacoustic measurement method is developed for piezoelectric acoustic logging transmitters. Unlike conventional small-signal impedance analysis, the proposed method synchronously measures the terminal voltage, terminal current, and 1 m hydrophone response under the same high-voltage short-burst excitation condition. A three-cycle sinusoidal burst was amplified and applied to a water-loaded PZT-5A tube transducer over an 8–100 kHz frequency sweep. For the finite-cycle non-steady-state waveforms, adaptive time-window extraction and single-frequency projection were used to obtain the dynamic apparent impedance, instantaneous power, single-burst input energy, effective short-burst transmitting voltage response, and hydrophone direct-wave voltage energy. The results show that small-signal impedance spectra measured in air and water can identify modal characteristics and candidate frequency bands, but they cannot directly represent the actual high-voltage short-burst operating state. The single-burst input energy shows a stronger frequency-dependent association with the hydrophone direct-wave voltage energy than the impedance magnitude or current amplitude alone. To further evaluate practical applicability, eight nominally identical acoustic logging transmitters were characterized using both conventional small-signal impedance analysis and the proposed high-voltage short-burst method, and their transmitting performances were independently evaluated in a natural-rock model well. The high-voltage dynamic conductance and, in particular, the single-burst input energy showed substantially stronger correspondence with the received P-wave voltage energy than the conventional small-signal conductance. The proposed method provides a practical measurement basis for evaluating acoustic logging transmitters under realistic short-burst excitation conditions, while the eight-transmitter model-well experiment provides preliminary support for its potential use in transmitter screening.