Rudolf Gerlich

Mr. Rudolf Gerlich


Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 October 2026 in Actuators
Verified
Journal Article
Open access
PDF file
JVJonah Vennemann
Jonah Vennemann
NKNiklas König
Niklas König
RGRudolf Gerlich
Rudolf Gerlich
MNMatthias Nienhaus
Matthias Nienhaus
Methods for self-sensing position determination in active magnetic bearings enable a reduction in system costs and complexity. Many well-known methods rely on current measurements or their derivatives to estimate the rotor’s displacement relative to the centre. However, measuring voltage often yields a better signal-to-noise ratio compared to current measurements, especially considering smaller machines where the current is often sensed using a shunt. Nevertheless, star-connected active magnetic bearings and the associated star-point voltage are rarely addressed in research. The star-point voltage provides valuable information for self-sensing position determination in other types of electric machines, such as permanent magnet synchronous motors. The goal of this research is to exploit the star-point voltage of an active magnetic bearing to estimate the rotor position. This study presents an analytical derivation of the star-point voltage for a four-phase active magnetic bearing, followed by a description of a differential measurement method for the star-point voltage. It is shown that, under the selected operating conditions, the resulting measured values depend exclusively on the coil inductance and the known DC supply voltage. To extract the position information from the obtained signal, the system was characterized at a standstill. The resulting measured values were used for polynomial fits, which were implemented on the microcontroller. Finally, the proposed method was experimentally validated inside the control loop under quasi static conditions. Experiments conducted on a laboratory prototype with a large air gap of 2 mm showed an RMS value of the estimation error ranging from 9.2 μm to 36.9 μm and a signal-to-noise ratio of approximately 70 dB.