A recent analytical model predicts free, entrapped, and residual LNAPL saturations and the LNAPL transmissivity in the subsurface from current and historic fluid levels in groundwater wells. As such, the model accounts for effects of fluid level fluctuations in a well. The model was developed to predict LNAPL specific volumes and transmissivities from current fluid level measurements in wells and either recorded historic fluid level fluctuations in wells or estimates. An assumption is made in the model that the predictions are not dependent on whether the historic highest or lowest fluid level elevations in a well occur first. To test the assumption, we conduct two simulations with a modified multiphase flow numerical code TMVOC that incorporates relative permeability‐saturation‐capillary head relations employed in the model. In one simulation, the initial condition is for fluid levels in a well at the historic highest elevations. In the other simulation, the initial condition is for fluid levels in a well at the historic lowest elevations. We change the boundary conditions so both historical conditions occur followed by generating the current condition. Results from the numerical simulations are compared to model predictions and show the assumption in the analytical model is reasonable. The analytical model can be used to develop/refine conceptual site models and for assessing potential LNAPL recovery endpoints, especially on sites with fluctuating fluid levels in wells.
We investigate the movement of LNAPL (light non-aqueous phase liquid) into and out of monitoring wells in an immediate-scale experimental cell. Aquifer material grain size and LNAPL viscosity are two factors that are varied in three experiments involving lowering and rising water levels. There are six monitoring wells at varying distances from a LNAPL injection point and a water pumping well. We established steady water flow through the aquifer materials prior to LNAPL injection. Water pumping lowered the water levels in the aquifer materials. Terminating water pumping raised the water levels in the aquifer materials. Our focus was to record the LNAPL thickness in the monitoring wells under transient conditions. Throughout the experiments, we measured the elevations of the air-LNAPL and LNAPL-water interfaces in the monitoring wells to obtain the LNAPL thicknesses in the wells. We analyze the results and give plausible explanations. The data presented can be employed to test multiphase flow numerical models.
2 August 2019 in Environmental Science and Pollution Research
Knowledge of subsurface light nonaqueous phase liquid (LNAPL) saturation is important for developing a conceptual model and a plan for addressing LNAPL contaminated sites. Investigators commonly predict LNAPL mobility and potential recoverability using information such as LNAPL physical properties, subsurface characteristics, and LNAPL saturations. Several models exist that estimate the LNAPL specific volume and transmissivity from fluid levels in monitoring wells. Commonly, investigators use main drainage capillary pressure–saturation relations because they are more frequently measured and available in the literature. However, main drainage capillary pressure–saturation relations may not reflect field conditions due to capillary pressure–saturation hysteresis. In this paper, we conduct a preliminary test of a recent analytical model that predicts subsurface LNAPL saturations, specific volume, and transmissivity against data measured at a LNAPL contaminated site. We call our test preliminary because we compare only measured and predicted vertical LNAPL saturations at a single site. Our results show there is better agreement between measured and predicted LNAPL saturations when imbibition capillary pressure–saturation relations are employed versus main drainage capillary pressure–saturation relations. Although further testing of the model for different conditions and sites is warranted, the preliminary test of the model was positive when consideration was given to capillary pressure–saturation hysteresis, which suggests the model can yield reasonable predictions that can help develop and update conceptual site models for addressing subsurface LNAPL contamination. Parameters describing capillary pressure–saturation relations need to reflect conditions existing at the time when the fluid levels in a well are measured.
An overview of the historical development of k-S-P relations (constitutive relations) to model potential flow of light nonaqueous phase liquids (LNAPLs) in the subsurface is presented in this chapter. The focus is advancements proposed by Parker, Lenhard, and colleagues over time. Discussion includes constitutive relations for incorporation in numerical multiphase flow models as well as constitutive relations for predicting subsurface LNAPL volumes and transmissivities from fluid levels measured in monitoring groundwater wells. LNAPL saturation distributions are given for various subsurface properties and layering sequences.