Jarmila Oremusová

Dr. Jarmila Oremusová


Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 February 2019 in Molecules
Verified
Journal Article
Open access
PDF file
JOJarmila Oremusová
Jarmila Oremusová
ZVZuzana Vitková
Zuzana Vitková
AVAnton Vitko
Anton Vitko
JOJarmila Oremusová
Jarmila Oremusová
EMEva Miklovičová
Eva Miklovičová
DKDaniel Krchňák
Daniel Krchňák
The paper analyses influences of the temperature and hydrophilic groups on micellar properties of ionic surfactants with 12-carbonic hydrophobic chains. The aim is to assess the impact of hydrophilic groups and temperature on thermodynamic parameters and micellization. This knowledge is indispensable for the formulation of new dosage forms. The method uses conductometric measurements. The following hydrophilic groups are analyzed: trimethylammonium bromide, trimethylammonium chloride, ethyldimethylammonium bromide, didodecyldimethylammonium bromide, pyridinium chloride, benzyldimethyl-ammonium chloride, methylephedrinium bromide, cis and trans-[(2-benzyloxy)-cyclohexyl-methyl]-N, N-dimethylammonium bromide, sodium sulphate and lithium sulphate. Except for a few cases, there is a good agreement between values of critical micellar concentrations (CMC) and critical vesicle concentration (CVC) obtained here and those which were obtained by other authors and/or by other physicochemical methods. Values of the CMC are compared with respect to the molar masses of hydrophilic groups. It was found that CMC values increased non-linearly with increasing system temperature. The degrees of counterion binding and thermodynamic parameters, like the standard molar Gibbs energy, enthalpy and entropy of micellization are determined and discussed in detail. The results obtained will be incorporated into in silico processes of modeling and design of optimal dosage forms, a current interdisciplinary research focus of the team.

1 May 2011 in Journal of Electrical Engineering
Verified
Journal Article
Closed access
JOJarmila Oremusová
Jarmila Oremusová
JMJán Murgaš
Ján Murgaš
Model Reference Adaptive Control of Permanent Magnet Synchronous Motor: In this paper the classical theory of the direct Model Reference Adaptive Control is used to develop a control algorithm for Permanent Magnet Synchronous Motor (PMSM). A PMSM model widely used in electric drives community is considered as base for control system development. Conventionally used controllers are replaced by adaptive ones. The resulting control system adapts to changes in any of PMSM parameters.

24 October 2017 in Molecules
Verified
Journal Article
Open access
PDF file
ZVZuzana Vitkova
Zuzana Vitkova
JOJarmila Oremusová
Jarmila Oremusová
PHPetra Herdová
Petra Herdová
OIOľga Ivánková
Oľga Ivánková
AVAnton Vitko
Anton Vitko
It is known that cationic surfactants have an antimicrobial effect and act as enhancers. This paper studies three cationic surfactants from the group of alkyldimethylbenzylammonium chlorides (dodecyl-, tetradecyl-, and hexadecyl). Interest is focused on the association of the surfactants with respect to temperature, partition balances and their influence on drug release, rheological properties, and the pH of hydrogels. The critical micelle concentrations (CMC) of the surfactants were estimated from dependencies of conductivity, density, spectrofluorimetry, and UV–VIS spectrophotometry on molarity in the temperature range of 25–50 °C. It was found that the temperature dependence of a CMC is U-shaped, with its minimum at 30 °C, and the CMC value decreases as the length of the chain increases. The pseudo-phase separation model was used for the calculation of various thermodynamic parameters, such as the Gibbs free energies (spontaneous process), enthalpies (exothermic process), and entropies of the micelles’ formation, CMCs, and the degree of counterion binding. All thermodynamic parameters, as functions of the temperature, were estimated. It was found that partition coefficients increase as the length of the alkyl chain and the pH = (5.0–7.0) increase. The influences of surfactants, below and above the CMC, on drug (chlorhexidine dihydrochloride) release from hydrogels, rheological properties, and pH at 30 °C were studied. Also, the amounts of the released drug increase as the alkyl chains of the surfactants prolongate. The amounts of the released drug with the surfactant below the CMC are greater than that above the CMC. All hydrogels (regardless of the length of the alkyl chain) exhibit a non-Newtonian pseudo-plastic flow. The results obtained will be used in the formulation of the drug and surfactants into dosage forms.

15 September 2021 in Molecules
Verified
Journal Article
Open access
PDF file
ZVZuzana Vitková
Zuzana Vitková
JOJarmila Oremusová
Jarmila Oremusová
JPJarmila Pavlovicova
Jarmila Pavlovicova
JMJán Murgaš
Ján Murgaš
Andrej BabinecAndrej Babinec
Andrej Babinec
AVAnton Vitko
Anton Vitko
Depending on their concentrations the surface-active substances, tensides (surfactants) can positively or negatively influence the drug absorption, which is widely used in the design of the dosage forms with controlled release. A problem is that the (in-vivo) rate of absorption cannot be directly measured and for that reason, it is frequently substituted by evaluation of the (in-vitro) dissolution. On other hand, a suitably designed pharmacokinetic model can directly predict virtually all pharmacokinetic quantities including both the rate of absorption and fraction of the dose reaching the blood circulation. The paper presents a new approach to the analysis of the rate of drug absorption and shows its superiority over traditional in-vivo approaches. Both the in-vivo analysis and model-based prediction of the tenside (monolaurin of sucrose) influence on the rate of absorption of the drug (sulfathiazole) after instantaneous per-oral administration to rats are discussed. It was found that 0.001% solution of tenside can increase the rate of absorption by cca 50% and a two-fold increase in absolute bioavailability can be reached. Attention is also devoted to the formal requirements laid on the model’s structure and its identifiability. The systematic design, substantiation and validation of a parsimonious predictive model that confirms in-vivo results are presented. The match between in-vivo observations and model-based predictions is demonstrated. The frequently overlooked metaphysics lying behind the compartmental modelling is briefly explained.

15 July 2014 in Tenside Surfactants Detergents
Verified
Journal Article
Closed access
JOJarmila Oremusová
Jarmila Oremusová
ZVZuzana Vitkova
Zuzana Vitkova
PHPetra Herdová
Petra Herdová
An objective of this work is analysis of influence of selected alcohols from the group of enhancers (ethanol, propan-1-ol, propan-2-ol) and humectants (ethane-1,2-diol, propane-1,2-diol and propane-1,2,3-triol) in the hydrogels containing carbethopendecinium bromide on their associative (critical micelle concentration and thermodynamic parameters) and release properties (pH, percentage of drug release and the release rate constant). The studied hydrogels contained constant amounts of the gel-creating basis (polymer chitosan – 2.5% w/w), drug carbethopendecinium bromide (Septonex) – 1.0% w/w and additive of alcohol in 5 and 10% w/w concentrations. Associative parameter – critical micelle concentration (CMC) was evaluated by conductometric measurements. The CMC significantly increased in the environment of alcohols in comparison with water solutions as many as 50 times, while concentration of alcohols ranged within W = 0–100% mass fractions. Micellization in the both environments was spontaneous (ΔGm < 0), and from the energetic point of view it was exothermic (ΔHm < 0). The additive of alcohols in hydrogels supported the drug relase from hydrogels. As the concentration of alcohols increased the mass percentage of the drug released from gel increased as well.

1 April 2007 in Die Pharmazie
Verified
Journal Article
Closed access
JOJarmila Oremusová
Jarmila Oremusová
ZVZ. Vitková
Z. Vitková
In this study the adsorption, partition and releasing balances of terbinafine hydrochloride have been studied. The adsorption isotherms of antifugal drug terbinafine hydrochloride (terbinafine), on the base of its adsorption from aqueous solutions on the surface of activated charcoal, were obtained in the temperature range of 25 to 45 °C used UV VIS spectrophotometric method. The experimental data have been analyzed by Freundlich and Langmuir equations to obtain parameters describing properly this adsorption process. The thermodynamic parameters (average change molar Gibbs energy – ΔadG0, enthalpy – ΔadH0 and entropy – ΔadS0) were calculated and compared. The partition coefficient of terbinafine hydrochloride in the system organic phase/water phase with different organic phases (n-butyalcohol, n-hexylalcohol and n-octylalcohol) using the “shake flask” method have been studied. The experimental partition coefficient of terbinafine increased from butylalcohol to octylacohol in the partitioning system. The influence of the concentration of polymer – hydroxy ethyl cellulose (HEC) (2–3%) used for preparation of the hydrogel (terbinafine-HEC-water), on terbinafine release has been studied. Both the concentrations of polymer and the drug had influence on the release process.