Rana Faisal Tufail

Mr. Rana Faisal Tufail

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 July 2019 in Materials
Verified
Journal Article
Open access
PDF file
Nasir ShafiqNasir Shafiq
Nasir Shafiq
RKRabinder Kumar
Rabinder Kumar
MZMUHAMMAD ZAHID
MUHAMMAD ZAHID
RTRana Faisal Tufail
Rana Faisal Tufail
This paper discussed the effects of modified metakaolin (MK) with nano-silica (NS) on the mechanical properties and durability of concrete. In the first phase, trial mixes of concrete were prepared for achieving the desired value of the 28 days compressive strength, and the charge passed in rapid chloride permeability test (RCPT). In the second phase, statistical analysis was performed on the experimental results using the response surface method (RSM). The RSM was applied for optimizing the mix proportions for the required performance by exploiting the relationship between the mix characteristics and the corresponding test results. A blend of 10% MK + 1% NS as part of cement replacement exhibited the highest mechanical properties and durability characteristics of concrete; concrete mix showed that the 28-days compressive strength (CS) was 103 MPa, which was 15% greater than the CS of the control mix without MK or NS. The same mix showed more than 40% higher flexural and split-tensile strength than the control mix; also it resulted in a reduction of 73% in the rapid chloride permeability value. ANOVA technique was used for optimizing the nano-silica and metakaolin content for achieving maximum compressive strength and minimum RCPT value. Statistical analysis using ANOVA technique showed that the maximum compressive strength and lowest RCPT value could be achieved with a blend of 10% MK and 1.55% NS.

27 February 2019 in Civil Engineering Journal
Verified
Journal Article
Open access
PDF file
XFXiong Feng
Xiong Feng
RTRana Faisal Tufail
Rana Faisal Tufail
MZMuhammad Zahid
Muhammad Zahid
Scrap tires that are dumped to landfill is a serious problem in China and rest of the world. The use of rubber in concrete is an effective environmental approach to reduce the amount of scrap tires around the world. However, the loss in compressive strength of concrete is a major drawback of rubberized concrete. In this paper, the fiber reinforced polymer (FRP) confinement technique is used to overcome the drawbacks of rubberized concrete (RuC). A total of sixty six RuC cylinders were tested in axial compression. The cylinders were cast using recycled rubber to replace, a) 0-50 percent fine aggregate volume, b) 0-50 percent coarse aggregate volume, and c) 40-50 percent fine and coarse aggregate volume. Twenty seven cylinders of the latter mix were then confined with one, two and three layers of CFRP jackets. Concrete suffered a substantial reduction in compressive strength up to 80 percent by fine and coarse aggregate replacement with rubber content. However, CFRP jackets recovered and further enhanced the axial compressive strength of RuC up to 600% over unconfined RuC. SEM was performed to investigate the microstructural properties of RuC. Statistical models were developed on the basis of experimental tests for FRP confined RuC cylinders using response surface method. The effect of variable factors; unconfined concrete strength, rubber replacement type and number of FRP layers on confined compressive concrete strength was investigated. The regression analysis was performed to develop the response equations based on quadratic models. The predicted and experimental test results were found in good agreement as the variation between experimental and predicted values were less than 5%. Furthermore, the difference between predicted and adjusted R2 was found to be less than 0.2 which shows the significance of the statistical models. These proposed statistical models can provide a better understanding to design the experiments and the parameters affecting FRP-confined RuC cylinders.

22 September 2021 in Advances in Structural Engineering
Verified
Journal Article
Closed access
PDF file
SASaeed Ahmad
Saeed Ahmad
Ayub ElahiAyub Elahi
Ayub Elahi
RTRana Faisal Tufail
Rana Faisal Tufail
MZMuhammad Zahid
Muhammad Zahid
STSaad Bin Tariq
Saad Bin Tariq
This paper presents an experimental study on shear strengthening of reinforced concrete (RC) deep beams using externally applied carbon fiber reinforced polymer (CFRP) jackets. A total of 18 RC deep beams were tested using a four-point bending load. The examined parameter included span to depth ratio with or without CFRP strengthening. CFRP strips were applied perpendicular to the probable crack pattern as observed during testing for un-strengthened beams. The properties that is cracking behavior, ultimate strength, deflection, and energy dissipation capacity of beams were evaluated and discussed. The test results showed enhancement in shear strength up to 17% with CFRP. An increase in depth of RC deep beams caused a decrease in the rate of enhancement in shear strength for CFRP strengthened beams as compared to that observed in their counterparts. The experimental test results were compared with the existing design guidelines to assess their application for RC deep beams strengthened with CFRP. A strength equation based on regression analysis was developed to predict the experimental shear strength of RC deep beams strengthened with CFRP. This study showed that the RC deep beams strengthened with CFRP can effectively be used in structural engineering applications with enhanced shear strength and energy absorption capacity.

9 May 2020 in Sādhanā
Verified
Journal Article
Closed access
PDF file
RTRana Faisal Tufail
Rana Faisal Tufail
XFXiong Feng
Xiong Feng
MZMuhammad Zahid
Muhammad Zahid
NUNodir Utashev
Nodir Utashev
TMTahir Mehmood
Tahir Mehmood
HSHammad Salahuddin
Hammad Salahuddin