Evening out the heat: The conversion of precursors into the active layer of perovskite solar cells normally occurs by heating the underlying substrate. Conversion tends to occur near the top of the film, where solvent is lost, and unwanted preheating of reactants occurs near the substrate before the reaction. Li et al . show that the use of a surrounding heat transfer oil (anisole) leads to more rapid and even heating, removes solvent, and avoids air and water contamination effects. The larger grains and more uniform films led a much greater retention of efficiency in moving from small-area to large-area devices. —PDS

The mixtures of cations and anions used in hybrid halide perovskites for high-performance solar cells often undergo element and phase segregation, which limits device lifetime. We adapted Schelling’s model of segregation to study individual cation migration and found that the initial film inhomogeneity accelerates materials degradation. We fabricated perovskite films (FA _1–x Cs _x PbI ₃ ; where FA is formamidinium) through the addition of selenophene, which led to homogeneous cation distribution that retarded cation aggregation during materials processing and device operation. The resultant devices achieved enhanced efficiency and retained >91% of their initial efficiency after 3190 hours at the maximum power point under 1 sun illumination. We also observe prolonged operational lifetime in devices with initially homogeneous FACsPb(Br _0.13 I _0.87 ) ₃ absorbers.