We introduce a novel electromagnetic interference suppression method based on the piezoelectric effect for switch-mode power supplies (SMPSs). A piezoelectric interference-suppression component (PISC) generates a low-impedance propagation path for conducted emissions at its resonance frequency. This results in an attenuation of a discrete disturbance peak. Besides the resonance frequency, the PISC features capacitive behavior. Thus, PISCs can not only substitute regular capacitors (e.g., Y-capacitors), but also provide selective attenuation at discrete frequencies. Moreover, PISCs have the potential to reduce size, weight, and cost of SMPSs because the filter size can be reduced while still fulfilling electromagnetic interference regulations through the use of the PISC. We proof this concept by integrating the PISC in a flyback converter and investigate the attenuation of the common-mode disturbance. In addition, the influence of frequency shifts for the circuitry and the PISC is evaluated. In our measurements, the PISC suppresses a discrete disturbance peak at the switching frequency by 45 dB, which was found to be 17 dB better than the conventional approach. Furthermore, determining factors for a proper usage in SMPS, such as temperature dependence, safety ratings, etc., were examined, and an appropriate design procedure is given. Finally, typical application scenarios for PISCs are described.
We present a two-stage energy extraction circuit for a piezoelectric energy harvester, powering an asset-tracking system. Exploiting accelerations generated by many logistic transport devices, e.g., pushcarts, forklifts, assembly belts or cars, we are able to harvest sufficient electrical energy to transmit radio signals, which will allow to track an object when it is moving. Accelerations in logistic applications are non-sinusoidal and lead to high open-circuit voltages, which demand a special adaption of the energy extraction network. We evaluate the performance of several state-of-the-art energy extraction networks and compare those to the performance of our two-stage approach under various excitation conditions. By using the proposed energy extraction circuit, the transmission rate could be increased from four to six transmissions per second for sinusoidal excitations with an open-circuit-voltage of . In the practical use-case, the two-stage energy extraction network performs more than two times better compared to the one-stage and synchronized switching harvesting with inductor approach.
We present an electromechanical energy harvester based on the piezoelectric effect. The piezoelectric energy harvester (PEH) consists of PZT materials glued on a cantilever with tipmass. Using this setup, the mechanical energy of ambient vibration is converted into electrical energy. It is possible to define an optimized height profile of the cantilever for maximum power output by analytical methods. This geometry is approximated by a linear profile for manufacturing purposes. We verify our experimental results with finite element (FE) simulations. To make this harvesting technique suitable for various applications, it has to be miniaturized. We measure, simulate and compare power outputs of a tailored harvester with respect to different electrical loads.
We present a two-stage energy extraction circuit for a piezoelectric energy harvester, powering an asset-tracking system. Exploiting non-sinusoidal accelerations generated by many logistic transport devices, e.g., pushcarts, forklifts, assembly belts or cars, we are able to harvest sufficient electrical energy to transmit radio signals, which will allow to track the object when it is moving. By using the proposed energy extraction circuit, the energy extraction efficiency could be improved by at least 30% compared to a single-stage solution for sinusoidal excitations. In the practical use-case, the two-stage energy extraction network performs more than four times better compared to the single staged on.