We introduce a novel electromagnetic interference suppression method based on the piezoelectric effect for switch-mode power supplies (SMPSs). A piezoelectric interference-suppression component (PISC) generates a low-impedance propagation path for conducted emissions at its resonance frequency. This results in an attenuation of a discrete disturbance peak. Besides the resonance frequency, the PISC features capacitive behavior. Thus, PISCs can not only substitute regular capacitors (e.g., Y-capacitors), but also provide selective attenuation at discrete frequencies. Moreover, PISCs have the potential to reduce size, weight, and cost of SMPSs because the filter size can be reduced while still fulfilling electromagnetic interference regulations through the use of the PISC. We proof this concept by integrating the PISC in a flyback converter and investigate the attenuation of the common-mode disturbance. In addition, the influence of frequency shifts for the circuitry and the PISC is evaluated. In our measurements, the PISC suppresses a discrete disturbance peak at the switching frequency by 45 dB, which was found to be 17 dB better than the conventional approach. Furthermore, determining factors for a proper usage in SMPS, such as temperature dependence, safety ratings, etc., were examined, and an appropriate design procedure is given. Finally, typical application scenarios for PISCs are described.
We present a two-stage energy extraction circuit for a piezoelectric energy harvester, powering an asset-tracking system. Exploiting accelerations generated by many logistic transport devices, e.g., pushcarts, forklifts, assembly belts or cars, we are able to harvest sufficient electrical energy to transmit radio signals, which will allow to track an object when it is moving. Accelerations in logistic applications are non-sinusoidal and lead to high open-circuit voltages, which demand a special adaption of the energy extraction network. We evaluate the performance of several state-of-the-art energy extraction networks and compare those to the performance of our two-stage approach under various excitation conditions. By using the proposed energy extraction circuit, the transmission rate could be increased from four to six transmissions per second for sinusoidal excitations with an open-circuit-voltage of . In the practical use-case, the two-stage energy extraction network performs more than two times better compared to the one-stage and synchronized switching harvesting with inductor approach.
Ceramic materials are chemical- and temperature-resistant and, therefore, enable novel application fields ranging from automotive to aerospace. With this in mind, this contribution focuses on developing an additive manufacturing approach for 3D-printed waveguides made of ceramic materials. In particular, a special design approach for ceramic waveguides, which introduces non-radiating slots into the waveguides sidewalls, and a customized metallization process, are presented. The developed process allows for using conventional stereolithographic desktop-grade 3D-printers. The proposed approach has, therefore, benefits such as low-cost fabrication, moderate handling effort and independence of the concrete waveguide geometry. The performance of a manufactured ceramic WR12 waveguide is compared to a commercial waveguide and a conventionally printed counterpart. For that reason, relevant properties, such as surface roughness and waveguide geometry, are characterized. Parsing the electrical measurements, the ceramic waveguide specimen features an attenuation coefficient of 30–60 dB/m within the E-Band. The measured attenuation coefficient is 200% and 300% higher compared to the epoxy resin and the commercial waveguide and is attributed to the increased surface roughness of the ceramic substrate.
We present a two-stage energy extraction circuit for a piezoelectric energy harvester, powering an asset-tracking system. Exploiting non-sinusoidal accelerations generated by many logistic transport devices, e.g., pushcarts, forklifts, assembly belts or cars, we are able to harvest sufficient electrical energy to transmit radio signals, which will allow to track the object when it is moving. By using the proposed energy extraction circuit, the energy extraction efficiency could be improved by at least 30% compared to a single-stage solution for sinusoidal excitations. In the practical use-case, the two-stage energy extraction network performs more than four times better compared to the single staged on.