This paper offers a complete and verified model of DC trolleybus grids and examines the effect of the common modelling assumptions made in literature by using simulations, as well as bus and substation measurements from the grid of Arnhem, the Netherlands. An equivalent model for the overhead line impedance is offered taking into account the single line impedance, the supply and return lines, and the parallel connections between them. A case study shows that the feeder cables from the substations to the sections can be ignored, but only for certain substation power and feeder-line length ranges. On the other hand, the often-neglected regenerative braking, bus auxiliaries load, bilateral connections, and the exact nominal substation voltage are found to be crucial for the correct modelling of a trolleybus grid.
The decarbonization of urban bus fleets can be made by their electrification as In-Motion-Charging (IMC) buses which can run both as trolleybuses or in battery-mode. The benefit is that IMC buses can use the existing trolleygrid infrastructure where their route overlaps with it to charge the battery, and operate in battery-mode outside of it. Presently, the IMC battery charging power is set conservatively to the minimum of all the spare capacities of the traction substations found along the bus route. This can render most electrification projects techno/economically infeasible as not enough energy is picked up for the battery-mode operation and long charging times at bus terminals are required. This paper proposes then an Adaptive Charging approach that uses the locally available spare capacity under any traction substation, taking into account the limitations of the maximum substation power and the minimum line voltage. The method is proven here both theoretically and in a case study over one full year of operation of four electrified diesel/CNG bus lines in Arnhem, the Netherlands, using comprehensive and verified trolleybus and trolleygrid models. The proposed Adaptive Charging method, as opposed to the present conservative method (here, Regular Charging), is shown to make one bus electrification project completely feasible, and reduce the extra terminal charging time for the other lines by up to 64%.