Silviu-Cristian Iriciuc

Dr. Silviu-Cristian Iriciuc

orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 November 2026 in Preprints.org
Verified
Preprint
Open access
PDF file
CPCatalin George POPOVICI
Catalin George POPOVICI
FTFlorin-Emilian Turcanu
Florin-Emilian Turcanu
Sebastian Valeriu HudisteanuSebastian Valeriu Hudisteanu
Sebastian Valeriu Hudisteanu
NCNelu-Cristian Cherecheș
Nelu-Cristian Cherecheș
IGIulian Gherasim
Iulian Gherasim
GGGimiga Gelu-Razvan
Gimiga Gelu-Razvan
Finite electric-heating panels are often assessed using transverse temperature profiles, although cable turns can alter whole-surface nonuniformity. This study reconstructs three Kanthal-heated panels from historical photographs, drawings and electrical resistances. Panel widths of 400, 500 and 600 mm correspond to cable pitches of 100, 150 and 200 mm. Three-dimensional multilayer Fourier solutions retain finite serpentine paths and are checked by independent finite-volume and MATLAB calculations. At 70 W m⁻², with adiabatic sides and a drawing-based length of 1.2 m, whole-surface ranges are 5.694, 5.595 and 5.926 K, compared with transverse-model values of 3.779, 3.560 and 3.512 K. P3 retains an almost unchanged mid-length range despite substantial end effects. Excluding 200 mm at each longitudinal end reverses the panel ranking. Twenty-four additional finite-volume cases test assumed lateral coefficients of 0, 2 and 8.3 W m⁻² K⁻¹, with refinement to 11.06 million control volumes. Whole-top variation exceeds mid-length variation throughout; final refinement changes whole-top ranges by less than 0.024 K. The results establish case-specific dependence on geometry, observation region and boundary losses. Historical experimental summaries remain conditional comparisons because sensor selection and boundary conditions are incompletely specified.

1 December 2021 in Bulletin of the Polytechnic Institute of Iași. Construction. Architecture Section
Verified
Journal Article
Open access
PDF file
SISilviu-Cristian Iriciuc
Silviu-Cristian Iriciuc
GGGelu Răzvan Gimiga
Gelu Răzvan Gimiga
IGIzabela Narciza GălușCă
Izabela Narciza GălușCă
The unprecedented scale of road network development programs in our country requires the consumption of materials (natural aggregates, binders), often non-renewable and expensive, which are difficult to secure from traditional sources. Alternative solutions for the replacement of natural aggregates, binders, as viable alternatives to classical technologies, the adoption and continuous development of recycling technologies are concerns of researchers, designers and road builders. So, the stabilized mixtures successfully form the sub-grade layers of the rigid road structures or both the sub-grade layers and the base layers of the semi-rigid structures (Zarojanu, 1976). Compared to traditional, untreated, thick foundations, the stabilized foundations, consisting of a series of thinner layers (assizes), with considerably increased rigidity, ensure a more judicious distribution of traffic loads for lower overall thicknesses of the road structure (Boboc, 1995).