In this investigation, biodiesel was produced from Moringa oleifera oil through a transesterification process at operating conditions including a reaction temperature of 60 °C, catalyst concentration of 1% wt., reaction time of 2 h, stirring speed of 1000 rpm and methanol to oil ratio of 8.50:1. Biodiesel blends, B10 and B20, were tested in a compression ignition engine, and the performance and emission characteristics were analyzed and compared with high-speed diesel. The engine was operated at full load conditions with engine speeds varying from 1000 rpm to 2400 rpm. All the performance and exhaust pollutants results were collected and analyzed. It was found that MOB10 produced lower BP (7.44%), BSFC (7.51%), and CO2 (7.7%). The MOB10 also reduced smoke opacity (24%) and HC (10.27%). Compared to diesel, MOB10 also increased CO (2.5%) and NOx (9%) emissions.
26 June 2017 in IOP Conference Series: Materials Science and Engineering
Transportation sector covers a large portion of the total energy consumption shares and is highly associated to global warming. Growing concern over the harmful gases being emitted from vehicles and their environmental implications has urged the need for pollutant reduction through more efficient engines. Good engine thermal management especially during cold-start warm up phase has been proven to enhance the engine efficiency in terms of fuel economy and greenhouse emissions specifically. In this study, the viability engine split cooling system was tested in two separate test. The parameters of interest include coolant and transmission temperature as these both parameters indicate the internal engine condition and highly associated with engine efficiency. In the first idle test, coolant temperature within the modified cooling configuration reached the optimum coolant temperature of 60 °C about 41.28% faster when compared to baseline configuration. The modified configuration also heat up the transmission oil around 4 times faster. In the second NEDC test which simulates the real time driving condition, the coolant of the modified vehicle reached the optimum temperature around 28.26% compared to the baseline.
This study reports the tribological characteristics of trimethylolpropane trioleate (TMPTO) additivated with antifriction and antiwear additives, which are ionic liquid (IL), glycerol monooleate (GMO), and molybdenum dithiocarbamate (MoDTC). In addition, to obtain the ideal composition that results in the minimal coefficient of friction (COF), optimization tool was employed using response surface methodology (RSM) technique with the Box–Behnken design. The IL used in this study was a phosphorus-type IL, namely trihexyl(tetradecyl)phosphonium bis(2,4,4-trimethylpentyl) phosphinate, [P14,6,6,6][TMPP]. The resulting COF and worn surface morphology were investigated using high-frequency reciprocating rig (HFRR) tribotester and scanning electron microscope with energy-dispersive X-ray spectroscopy (SEM-EDX), respectively. From the experimental results, a second-order polynomial mathematical model was constructed and able to statistically predict the resulting COF. The optimized values that resulted in the lowest average COF of 0.0458 were as follows: 0.93 wt% IL, 1.49 wt% GMO, and 0.52 wt% MoDTC. The addition of IL into neat base oil managed to reduce the COF, while the combination of IL, GMO, and MoDTC at optimum concentration further reduced the average COF and wear as observed through SEM micrographs when compared with those of additive-free TMPTO, suggesting that GMO and MoDTC were compatible to be used with IL.