Nickel–tungsten (Ni-W) alloys are gaining significant attention due to their superior hardness, wear resistance, anti-corrosion and electrochemical hydrogen evolution reaction (HER) activity. In this work, porous and crack Ni-W alloys with different W contents were prepared in a pyrophosphate bath. The key to forming a porous structure is a very high current density over 300 mA cm−2. The HER activity of porous and crack Ni-W alloys was studied by means of electrochemical technologies of linear sweep voltammetry (LSV), Tafel curves (Taf) and electrochemical impedance spectroscopy (EIS). Compared with the crack Ni-W alloy, the porous Ni-W alloy exhibits improved alkaline electrochemical HER performances, which can deliver a current density of 10 mA cm−2 at 166 mV (η10) vs. RHE (reversible hydrogen electrode).
2 May 2019 in Journal of the Electrochemical Society
Electrodeposited Ni-W alloy coating is considered as one of the most suitable candidate to replace the environmentally hazardous hexavalent hard chromium coatings. However, it is necessary to carry out heat-treatment at a high temperature to improve its microhardness and refine its grain. In the present work, an alternative high frequency induction heat-treatment (HFI-HT) technology was used to improve surface microhardness of Ni-W/SiC composite coatings, which were electrodeposited from an ammonium-citrate bath, containing suspended green SiC particles. Transformation of amorphous to crystalline structure can be observed after HFI-HT. The precipitation of a Ni6W6C phase rather than a Ni4W phase occurs by prolonging induction time to 64 s at a power density of 21 W mm−2 or turning power density up to 42 W mm−2 for 4 s. While the two phases of Ni6W6C and Ni4W can be precipitated at 900°C. The microhardness of Ni-W/SiC composite coatings can be improved up to 1100 HV with HFI-HT at 21 W mm−2 for 8 s, which is comparable to that of hard chrome coatings.