The radiation properties and the electronic structure of hybrid composites based on suspension polystyrene (PS) and nanocrystals of BaZrO3 (BZO) (d < 50 nm) have been studied using luminescent spectroscopy and x-ray analysis. A strong cathodoluminescence (CL) in BZO-nanocrystals is observed in temperature range 80–293 K. It is modified in BZO-PS composites: both the low- and a high-energy bands (near 4 eV) appear, together with a significant reduction in the CL intensity. A decrease of the lattice parameter a for BZO phase in the composite and the modification of CL spectra indicate for changes in the nanocrystalline structure induced by the polymer.
Systematic evaluation of the influence of radiation on the electrical response of hybrid nanocomposites obtained by adding multi-walled carbon nanotubes into poly(3,4-ethylenedioxythiophene) and poly(styrenesulfonate) host matrix is presented. Variations of resistance and conductivity of nanocomposites depending on the volume fraction of nanotubes in the matrix, ionizing radiation dosage, and temperature are analyzed.
11 February 2014 in Molecular Crystals and Liquid Crystals
The polymer encapsulated magnetic nanoparticles were obtained by suspension polymerization of styrene in the aqueous dispersion of magnetite. Functionalization of capsules was carried out by adsorption of BaZrO3luminescent nanocrystals on the polystyrene shell. Followed oxidative polymerization of aniline on the capsule surface leading to the additional encapsulation of the microspheres by conducting substance-polyaniline. It was found that adsorption of BaZrO3nanocrystals on polystyrene shell leads to modification of CL spectra due to chemical interaction between polystyrene and BaZrO3nanocrystals.
We studied an effect of the graphene oxide (GO) layer on the optical and electrical properties of porous silicon (PS) in hybrid PS–GO structure created by electrochemical etching of silicon wafer and deposition of GO from water dispersion on PS. With the help of scanning electron microscopy (SEM), atomic-force microscopy (AFM), and Fourier transform infrared (FTIR) spectroscopy, it was established that GO formed a thin film on the PS surface and is partly embedded in the pores of PS. A comparative analysis of the FTIR spectra for the PS and PS–GO structures confirms the passivation of the PS surface by the GO film. This film has a sufficient transparency for excitation and emission of photoluminescence (PL). Moreover, GO modifies PL spectrum of PS, shifting the PL maximum by 25 nm towards lower energies. GO deposition on the surface of the porous silicon leads to the change in the electrical parameters of PS in AC and DC modes. By means of current–voltage characteristics (CVC) and impedance spectroscopy, it is shown that the impact of GO on electrical characteristics of PS manifests in reduced capacitance and lower internal resistance of hybrid structures.
In this work, the hybrid structures were created by electrochemical etching of silicon wafer and deposition of reduced graphene oxide (RGO) on the porous silicon (PS) layer. With the help of SEM and AFM, the formation of hybrid PS–RGO structure was confirmed. By means of current–voltage characteristic analysis and impedance spectroscopy, we studied electrical characteristics of PS–RGO structures. The formation of photosensitive electrical barriers in hybrid structures was revealed. Temporal parameters and spectral characteristics of photoresponse in the 400–1100-nm wavelength range were investigated. The widening of spectral range of photosensitivity of the hybrid structures in short-wavelength range in comparison with single-crystal silicon was revealed. The obtained results broaden the prospects of application of the PS–RGO structures in photoelectronics.
In this work, we have prepared film sensor elements based on a hybrid system poly(3,4-ethylenedioxythiophene)-porous silicon nanocrystals-carbon nanotubes on flexible polymer substrates. Our FTIR spectroscopy-based studies for the molecular structure of the materials obtained suggest some interaction of their components in the hybrid layer. The influence of adsorption of water molecules on the conductivity and capacitance of the hybrid composites has been investigated in the temperature range of 20°C to 40°C. We have detected essential changes in the electrical conductivity and capacitance which depend on the humidity of the surrounding atmosphere. For estimating the sensing properties of our composites, we have analyzed the sensing abilities of the hybrid systems and their dynamic characteristics. The hybrid composites as working materials for the sensors provide improved performance of the latter. In particular, the response time is reduced by 3 to 5 times. 73.63.-b, 73.61.Ph, 82.35.Np, 81.05.Rm