This work focuses on the photovoltaic array fed water pumping system utilizing induction motor with the model developed in Matlab/Simulink. PV system is designed to avail the solar energy by means of Photovoltaic cells. It consists of an arrangement of several components, including solar panels to absorb and convert sunlight into electricity. Maximum Power Point Tracking is a technique used to maximize power output from the Photovoltaic module and finally a 3 phase induction motor is driven through it. In this paper a Photovoltaic array is used to run a induction motor that drives the centrifugal pump. The simulink model of the PV array connected to induction motor where MPPT technique (perturb and observable) plays an important role that is developed in MATLAB and the outputs are observed.
Among the total energy consumption by utilities, pumping systems contribute 30%. It is evident that a tremendous energy saving potential is achievable by improving the energy efficiency and reducing faults in the pumping system. Thus, optimal operation of centrifugal pumps throughout the operating region is desired for improved energy efficiency and extended lifetime of the pumping system. The major harmful operations in centrifugal pumps include cavitation and water hammering. The pump faults are simulated in a real-time experimental setup and the operating point of the pump is estimated correspondingly. In this article, the experimental power quality and vibration measurements of cascade pumps during cavitation and water hammering is recorded for different operating conditions. The results are compared with the normal operating conditions of the pumping system for fault prediction and parameter estimation in a cascade water pumping system. Moreover, the Fast Fourier Transform (FFT) analysis comparison of normal and water hammering (faulty condition) highlights the frequency response of the pumping system. Also, the various power quality issues, i.e., voltage, current, total harmonic distortion, power factor, and active, reactive, and apparent power for a cascade multipump control is discussed in this article. The vibration, FFT, and various power quality measurements serve as input data for the classification of faulty pump operating condition in contrast with the normal operation of pumping system.
21 October 2016 in Indian Journal of Science and Technology