This paper presents the design and fabrication of a broadband microstrip attenuator, operating at 1-20 GHz, based on few layer graphene flakes. The RF performance of the attenuator has been analyzed in depth. In particular, the use of graphene as a variable resistor is discussed and experimentally characterized at microwave frequencies. The structure of the graphene-based attenuator integrates a micrometric layer of graphene flakes deposited on an air gap in a microstrip line. As highlighted in the experiments, the graphene film can range from being a discrete conductor to a highly resistive material, depending on the externally applied voltage. As experimental evidence, it is verified that the application of a proper voltage through two bias tees changes the surface resistivity of graphene, and induces a significant change of insertion loss of the microstrip attenuator.

Carbon nanotubes were synthesized by thermal arc plasma process after optimization of the synthesis parameters. These samples were then analysed by scanning and transmission electron microscopes (SEM and TEM), in order to establish the morphology of the nanostructures. Atomic force microscopy (AFM) and electron diffraction studies were also carried out before using the sample for the composite material preparation. Composites of epoxy resin with curing agent as well as a mixture of graphite and carbon nanotubes were prepared with varying proportions of the mixture. The electrical resistivity of the material was studied under varying pressure and voltage conditions. Preliminary results of these studies present interesting features which are reported here.

MicroRNAs (miRNAs) directly regulate gene expression at a post-transcriptional level and represent an attractive therapeutic target for a wide range of diseases. Here, we report a novel strategy for delivering miRNAs to endothelial cells (ECs) to regulate angiogenesis, using polymer functionalized carbon nanotubes (CNTs). CNTs were coated with two different polymers, polyethyleneimine (PEI) or polyamidoamine dendrimer (PAMAM), followed by conjugation of miR-503 oligonucleotides as recognized regulators of angiogenesis. We demonstrated a reduced toxicity for both polymer-coated CNTs, compared with pristine CNTs or polymers alone. Moreover, polymer-coated CNT stabilized miR-503 oligonucleotides and allowed their efficient delivery to ECs. The functionality of PAMAM-CNT-miR-503 complexes was further demonstrated in ECs through regulation of target genes, cell proliferation and angiogenic sprouting and in a mouse model of angiogenesis. This comprehensive series of experiments demonstrates that the use of polyamine-functionalized CNTs to deliver miRNAs is a novel and effective means to regulate angiogenesis.

A comprehensive analysis of electrical, electromagnetic (EM), mechanical, and thermal properties of epoxy resin composites filled with 0.25–2.0 wt. % of carbon additives characterized by high surface area, both nano-sized, like carbon nanotubes (CNTs) and carbon black (CBH), and micro-sized exfoliated graphite (EG), was performed. We found that the physical properties of both CNTs- and CBH-based epoxy resin composites increased all together with filler content and even more clearly for CBH than for CNTs. In the case of EG-based composites, good correlation between properties and filler amount was observed for concentrations below 1.5 wt. %. We conclude that CBH and, to a lower extent, EG could replace expensive CNTs for producing effective EM materials in microwave and low-frequency ranges, which are, in addition, mechanically and thermally stable.