The NASA-sponsored Calibrated Passive Micro- wave Daily Equal-Area Scalable Earth Grid 2.0 Brightness Temperature (CETB) Earth System Data Record Project team has generated a multisensor, multidecadal time series of high-resolution radiometer products designed to support climate studies. This project uses image reconstruction techniques to generate conventional and enhanced-resolution daily brightness temperature images on a standard set of map projections. Sensors included in CETB are the Aqua Advanced Microwave Scanning Radiometer-Earth Observing System (AMSR-E), Scanning Multichannel Microwave Radiometer, and all Special Sensor Microwave/Imager and Special Sensor Microwave Imager/Sounder radiometers. These span frequencies between 6 and 89 GHz. This paper considers the issues of adding the L-band (1.6 GHz) Soil Moisture Active Passive (SMAP) radiometer measurements to the CETB climate record, with emphasis on optimizing the reconstruction to provide the highest possible spatial resolution at the lowest noise level. SMAP radiometer reconstruction on SMAP-standard grids is also considered. Simulation is used to optimize the reconstruction, and the results confirmed using actual data. A comparison of the performance of the Backus-Gilbert approach and the radiometer form of the Scatterometer Image Reconstruction algorithm is provided. These are compared to the conventional drop-in-the-bucket gridded imaging.

Mapping the spatial extent of recently identified englacial hydrological features (i.e., ice slabs and perennial firn aquifers) formed by meters-thick water-saturated firn layers over the percolation facies of the Greenland Ice Sheet using L -band microwave radiometry has recently been demonstrated. However, these initial maps are binary, and do not provide a parameter to estimate the spatial variability in the thickness and volumetric fraction of meltwater stored within the firn pore space. Here, we exploit enhanced-resolution vertical-polarization L -band brightness temperature ( $T_{V}^{B}$ ) imagery (2015–2019) generated using observations collected over Greenland by NASA’s Soil Moisture Active Passive (SMAP) satellite and a simple two-layer L -band brightness temperature model. We map water-saturated firn layers via a “firn saturation” parameter, and interpret our results together with ice slab and perennial firn aquifer spatial extents, estimates of snow accumulation simulated via the Regional Atmospheric Climate Model (RACMOp2.3), and airborne radar surveys collected via NASA’s Operation IceBridge (OIB) campaigns. We find that variable firn saturation parameter values are mapped in lower snow accumulation ice slab areas in western, northern, and northeastern Greenland, where firn is colder and water-saturated firn layers seasonally refreeze as solid-ice. Higher firn saturation parameter values are mapped in higher snow accumulation perennial firn aquifer areas in southeastern, southern, and northwestern Greenland, where firn is near the melting point, and meters-thick water-saturated firn layers exist. Our results have implications for identifying expansive englacial reservoirs that store significant volumes of meltwater in locations that are vulnerable to meltwater-induced hydrofracturing and accelerated outlet glacier flow year-round.

Since the late 1970s, satellite passive-microwave brightness temperatures have been a mainstay in remote sensing of the cryosphere. Polar snow and ice-covered ocean and land surfaces are especially sensitive to climate change and are observed to fluctuate on interannual to decadal timescales. In regions of limited sunlight and cloudy conditions, microwave measurements are particularly valuable for monitoring snow- and ice-covered ocean and land surfaces, due to microwave sensitivity to phase changes of water. Historically available at relatively low resolutions (25 km) compared to optical techniques (less than 1 km), passive-microwave sensors have provided short-timescale, large-area spatial coverage, and high temporal repeat observations for monitoring hemispheric-wide changes. However, historically available gridded passive microwave products have fallen short of modern requirements for climate data records, notably by using inconsistently-calibrated input data, including only limited periods of sensor overlaps, employing image-reconstruction methods that tuned for reduced noise rather than enhanced resolution, and using projection and grid definitions that were not easily interpreted by geolocation software. Using a recently completed Fundamental Climate Data Record of the swath format passive-microwave record that incorporated new, cross-sensor calibrations, we have produced an improved, gridded data record. Defined on the EASE-Grid 2.0 map projections and derived with numerically efficient image-reconstruction techniques, the Calibrated, Enhanced-Resolution Brightness Temperature (CETB) Earth System Data Record (ESDR) increases spatial resolution up to 3.125 km for the highest frequency channels, and satisfies modern Climate Data Record (CDR) requirements as defined by the National Research Council. We describe the best practices and development approaches that we used to ensure algorithmic integrity and to define and satisfy metadata, content and structural requirements for this high-quality, reliable, consistently gridded microwave radiometer climate data record.