Animal waste, including chicken manure, is a category of biomass considered for application in the energy industry. Poland is leading poultry producer in Europe, with a chicken population assessed at over 176 million animals. This paper aims to determine the theoretical and technical energy potential of chicken manure in Poland. The volume of chicken manure was assessed as 4.49 million tons per year considering three particular poultry rearing systems. The physicochemical properties of examined manure specimens indicate considerable conformity with the data reported in the literature. The results of proximate and ultimate analyses confirm a considerable effect of the rearing system on the energy parameters of the manure. The heating value of the chicken manure was calculated for the high moisture material in the condition as received from the farms. The value of annual theoretical energy potential in Poland was found to be equal to around 40.38 PJ. Annual technical potential of chicken biomass determined for four different energy conversion paths occurred significantly smaller then theoretical and has the value from 9.01 PJ to 27.3 PJ. The bigger energy degradation was found for heat and electricity production via anaerobic digestion path, while fluidized bed combustion occurred the most efficient scenario.

In this study, the combustion of olive byproducts was investigated using the TG-FTIR technique. Different types of olive biomass were considered: twigs, leaves, olive-mill waste from the two-phase decanting method, and wastewater from the three-phase system. The reaction regions, ignition, and burnout temperatures at different heating rates were determined using TG/DTG analysis and the thermogravimetry results. Comprehensive combustion, ignition, burnout, and flammability indexes were also calculated. The highest combustion index values were obtained for waste from the three-phase system, followed by the two-phase decanting method, then with leaves and small twigs. The order of the index values indicated that the sample from the three-phase process ignited more quickly and yielded faster. The changes in activation energy calculated using different model-free isoconversional methods—Friedman, Ozawa–Flynn–Wall, and Kissinger–Akahira–Sunose—fell within the range of 130–140 kJ/kmol. FTIR analyses presented differences in the exhaust gas composition for specific combustion temperature ranges.

Coal continues to dominate in the structure of the heat production system in some European countries. Coal-fired boilers in district heating and power generation systems are accompanied by the formation of large quantities of slag and ash. Due to considerable high temperature, slag may be used as a source of waste energy. In this study, the technical possibilities of recovery slag’s physical enthalpy from grate-fired district heating boiler of 45 MW thermal capacity are analyzed. The aim of the work is to estimate the waste energy potential of the slag in analyzed boiler and proposition of the heat recovery system. The construction and design of the existing deslagging system was examined. Studies have shown that high water temperature accelerates system wear. Recovering heat from this system decreases the water temperature, which extends the trouble-free working time. The slag parameters were determined, including the temperature at the outlet of the boiler and the temperature after leaving the slag water tub. The annual amount of heat regenerative potential was estimated. On the basis of the research, the authors propose a waste heat recovery facility with high temperature R134a heat pump system. The result of the conducted research is that the proposed heat pump provides energy savings that are worth considering by recovering from 58.8% to 88.0% of energy slag potential.