In the thermal spraying process, the porosity of ceramic coatings contributes directly to the efficiency of the thermal insulation. The size, shape, and distribution of the pores determine the level of both thermal and sintering resistance. In this work, three different atmospheric plasma sprayed (APS) alumina coatings were fabricated with the same spraying parameters using alumina powders with fine, medium, and coarse particle size. The microstructure of the obtained coatings was analyzed regarding the obtained total porosity, pore size, and pore shape. It was found that it is expedient to divide the pore size range into fine, medium, and large sizes. The shape was characterized with regard to the circularity aspect. In this way, all types of cracks can be considered as oblate pores and were included in the calculation of the total porosity. In the case of using fine feedstock powder, the densest coatings were produced among all coatings, and the fraction of fine pores and cracks are thereby substantially higher. However, the total porosity increases with increasing feedstock powder size. A connection was also made between thermal insulation and porosity fraction which includes fine pores and cracks.
18 March 2021 in Journal of Thermal Spray Technology
The integrity and properties of ceramic coatings produced by atmospheric plasma spraying are highly controlled by the splat morphology and splat interconnection. In this study, the influence of selected parameters (spray angle, surface velocity of the spray gun, and substrate temperature) on splat morphology and coating microstructure was investigated. A favorite set of spray gun parameters, of which their effects on splat morphology and coating microstructure have been verified by previous experiments, were used to conduct the experiments for the present work. It was found that depositing fully molten particles on a hot substrate increases the fraction of disk-like splats by about 60% at the expense of the fraction of irregular splats. Preheating the substrate also increases the pore count and level of coating porosity, while it does not influence the density of segmentation cracks. In contrast, the surface velocity of the spray gun does not affect the splat morphology while a slow speed decreases the coating porosity and plays a significant role in generating segmentation cracks. Shifting the spray angle by 15° distorts up to 20% of disk-like splats and slightly decreases the porosity level. However, changing the spray angle does not affect the generation of segmentation cracks.
24 October 2019 in Journal of Thermal Spray Technology
The effect of impact velocity and temperature of invar particles deposited by high-velocity oxygen fuel (HVOF) and cold spray processes on the microstructure and oxidation content of invar coatings is not fully understood. Additionally, the effect of coating thickness on the coefficient of thermal expansion (CTE) of the coated material and the influence of cold working on the coating hardness are also insufficiently investigated. In the present study, invar coatings were deposited at temperatures close to and below the melting point of invar particles to maintain low CTE. It was found that particle impact temperature and velocity strongly affect pore formation and cohesiveness but slightly affect the hardness of invar coatings. Higher particle impact velocities with impact temperatures close to the invar’s melting point enhance highly the cohesiveness of HVOF-invar coatings. Furthermore, invar coatings stabilize the CTE of the coated material up to a temperature of 227 °C. An increment in the coating’s thickness of 150 µm leads to reducing the CTE of the coated material (Al) in the in-plane direction by 7.65%. Applying cold working using 200 kN compression increases the hardness of the treated coatings by 6% while machine hammer peening (MHP) has a slight effect.