Reduction of engine-out NOx emissions to ultra-low levels is facilitated by enabling low temperature combustion (LTC) strategies. However, there is a significant energy penalty in terms of combustion efficiency as evidenced by the high levels of hydrocarbon (HC), carbon monoxide (CO), and hydrogen emissions. In this work, the net fuel energy lost as a result of incomplete combustion in two different LTC regimes is studied—partially premixed compression ignition (PPCI) using in-cylinder injection of diesel fuel and reactivity controlled compression ignition (RCCI) of port injected gasoline and direct injected diesel. A detailed analysis of the incomplete combustion products was conducted. Test results indicated that carbon monoxide (CO), hydrogen, and light hydrocarbon (HC) made up for most of the combustion in-efficiency in the PPCI mode, while heavier HC and aromatics were significantly higher in the RCCI mode.
21 September 2012 in Journal of Engineering for Gas Turbines and Power
Diesel low temperature combustion (LTC) is capable of producing diesel-like efficiency while emitting ultra-low nitrogen oxides (NOx) and soot emissions. Previous work indicates that well-controlled single-shot injection with exhaust gas recirculation (EGR) is an operative way of achieving diesel LTC from low to mid engine loads. However, as the engine load is increased, demanding intake boost and injection pressure are necessary to suppress high soot emissions during the transition to LTC. The use of volatile fuels such as ethanol is deemed capable of promoting the cylinder charge homogeneity, which helps to overcome the high soot challenge and, thus, potentially expand the engine LTC load range. In this work, LTC investigations were carried out on a high compression ratio (18.2:1) engine. Engine tests were first conducted with diesel and LTC operation at 8 bar indicated mean effective pressure (IMEP) was enabled by sophisticated control of the injection pressure, injection timing, intake boost, and EGR application. The engine performance was characterized as the baseline, and the challenges were identified. Further tests were aimed to improve the engine performance against these baseline results. Experiments were, hence, conducted on the same engine with secondary ethanol port fuelling (PF). Single-shot diesel direct injection (DI) was applied close to top dead center (TDC) to ignite the ethanol and control the combustion phasing. The control sensitivity was studied through injection timing sweeps and EGR sweeps. Additional tests were performed to investigate the ethanol-to-diesel ratio effects on the mixture reactivity and the engine emissions. Engine load was also raised to 16.4 bar IMEP while keeping the simultaneously low NOx and soot emissions. Significant improvement of engine control and emissions was achieved by the DI+PF strategy.
21 March 2014 in Journal of Engineering for Gas Turbines and Power
Suitable cylinder charge preparation is deemed critical for the attainment of a highly homogeneous, diluted, and lean cylinder charge, which is shown to lower the flame temperature. The resultant low temperature combustion (LTC) can simultaneously reduce the NOx and soot emissions from diesel engines. This requires sophisticated coordination of multiple control systems for controlling the intake boost, exhaust gas recirculation (EGR), and fueling events. Additionally, the cylinder charge modulation becomes more complicated in the novel combustion concepts that apply port injection of low reactivity alcohol fuels to replace the diesel fuel partially or entirely. In this work, experiments have been conducted on a single cylinder research engine with diesel and ethanol fuels. The test platform is capable of independently controlling the intake boost, EGR rates, and fueling events. Effects of these control variables are evaluated with diesel direct injection and a combination of diesel direct injection and ethanol port injection. Data analyses are performed to establish the control requirements for stable operation at different engine load levels with the use of one or two fuels. The sensitivity of the combustion modes is thereby analyzed with regard to the boost, EGR, fuel types, and fueling strategies. Zero-dimensional cycle simulations have been conducted in parallel with the experiments to evaluate the operating requirements and operation zones of the LTC combustion modes. Correlations are generated between air–fuel ratio (λ), EGR rate, boost level, in-cylinder oxygen concentration, and load level using the experimental data and simulation results. Development of a real-time boost-EGR set-point determination to sustain the LTC mode at the varying engine load levels and fueling strategies is proposed.