Permafrost is widely distributed in the Tibetan Plateau. Seasonal freeze–thaw cycles of permafrost result in upward and downward surface displacement. Multitemporal interferometric synthetic aperture radar (MT-InSAR) observations provide an effective method for monitoring permafrost displacement under difficult terrain and climatic conditions. In this study, a seasonal sinusoidal model-based new small baselines subset (NSBAS) chain was adopted to obtain a deformation time series. An experimental study was carried out using 33 scenes of Sentinel-1 data (S-1) from 28 November 2017 to 29 December 2018 with frequent revisit (12 days) observations. The spatial and temporal characteristics of the surface displacements variation combined with different types of surface land cover, elevation and surface temperature factors were analyzed. The results revealed that the seasonal changes observed in the time series of ground movements, induced by freeze–thaw cycles were observed on flat surfaces of sedimentary basins and mountainous areas with gentle slopes. The estimated seasonal oscillations ranged from 2 mm to 30 mm, which were smaller in Alpine deserts than in Alpine meadows. In particular, there were significant systematic differences in seasonal surface deformation between areas near mountains and sedimentary basins. It was also found that the time series of deformation was consistent with the variation of surface temperature. Based on soil moisture active/passive (SMAP) L4 surface and root zone soil moisture data, the deformation analysis influenced by soil moisture factors was also carried out. The comprehensive analysis of deformation results and auxiliary data (elevation, soil moisture and surface temperature et al.) provides important insights for the monitoring of the seasonal freeze-thaw cycles in the Tibetan Plateau.

The three-dimensional (3-D) displacements of mining areas is the basis of studying the mining subsidence law and obtaining surface movement parameters. The traditional multi-temporal interferometry synthetic aperture radar (InSAR) technology can only obtain the surface deformation in line-of-sight (LOS) direction, even if some methods can obtain the 3-D displacements of mining area based on InSAR. However, it has high data requirements for data types, which are not conducive to the inversion of 3-D displacements. In this paper, the symmetry of the surface basin caused by mining subsidence under different mining degrees is analyzed. According to the basic symmetrical features of mining subsidence—that the surface vertical displacement and horizontal displacement in near horizontal coal seam is symmetrical with respect to the main section of the basin, combined with time series InSAR technology (TS-InSAR)—a novel method for retrieving the 3-D displacement results from a single-geometry InSAR dataset based on symmetrical features (hereafter referred to as the SGI-SF method) is proposed. The SGI-SF method first generates multi-temporal observations of LOS displacement from a single-geometry InSAR dataset, and then transforms them into multi-temporal observations of 3-D displacement datasets according to symmetrical features. There is no necessity to obtain the surface movement parameters from the measured data to calculate 3-D displacement fields. Finally, the time series of 3-D displacements are estimated from multi-temporal 3-D displacements using the singular value decomposition (SVD) method. Nine descending Sentinel-1 images from the Yulin mining area of China are used to test the proposed SGI-SF method. The results show that the average root mean square errors (RMSE) in the vertical and horizontal direction of the three-dimensional deformations are approximately 9.28 mm and 13.10 mm, respectively, which are much smaller than mining-induced displacements and can provide support for deformation monitoring in mining areas.

The Qinghai-Tibet Railway (QTR) is the railway with the highest elevation and longest distance in the world, spanning more than 1142 km from Golmud to Lhasa across the continuous permafrost region. Due to climate change and anthropogenic activities, geological disasters such as subsidence and thermal melt collapse have occurred in the QTR embankment. To conduct the large-scale permafrost monitoring and geohazard investigation along the QTR, we collected 585 Sentinel-1A images based on the composite index model using the multitrack time-series interferometry synthetic aperture radar (MTS-InSAR) method to retrieve the surface deformation over a 3.15 × 10⁵ km² area along the QTR. Meanwhile, a new method for permafrost distribution mapping based on InSAR time series deformation was proposed. Finally, the seasonal deformation map and a new map of permafrost distribution along the QTR from Golmud to Lhasa were obtained. The results showed that the estimated seasonal deformation range of the 10 km buffer zone along the QTR was −50–10 mm, and the LOS deformation rate ranged from −30 to 15 mm/yr. In addition, the deformation results were validated by leveling measurements, and the range of absolute error was between 0.1 and 4.62 mm. Most of the QTR was relatively stable. Some geohazard-prone sections were detected and analyzed along the QTR. The permafrost distribution results were mostly consistent with the simulated results of Zou’s method, based on the temperature at the top of permafrost (TTOP) model. This study reveals recent deformation characteristics of the QTR, and has significant scientific implications and applicational value for ensuring the safe operation of the QTR. Moreover, our method, based on InSAR results, provides new insights for permafrost classification on the Qinghai-Tibet Plateau (QTP).

The dynamic changes of the thawing and freezing processes of the active layer cause seasonal subsidence and uplift over a large area on the Qinghai–Tibet Plateau due to ongoing climate warming. To analyze and investigate the seasonal freeze–thaw process of the active layer, we employ the new small baseline subset (NSBAS) technique based on a piecewise displacement model, including seasonal deformation, as well as linear and residual deformation trends, to retrieve the surface deformation of the Beiluhe basin. We collect 35 Sentinel-1 images with a 12 days revisit time and 9 TerraSAR-X images with less-than two month revisit time from 2018 to 2019 to analyze the type of the amplitude of seasonal oscillation of different ground targets on the Beiluhe basin in detail. The Sentinel-1 results show that the amplitude of seasonal deformation is between −62.50 mm and 11.50 mm, and the linear deformation rate ranges from −24.50 mm/yr to 5.00 mm/yr (2018–2019) in the study area. The deformation trends in the Qinghai–Tibet Railway (QTR) and Qinghai–Tibet Highway (QTH) regions are stable, ranging from −18.00 mm to 6 mm. The InSAR results of Sentinel-1 and TerraSAR-X data show that seasonal deformation trends are consistent, exhibiting good correlations 0.78 and 0.84, and the seasonal and linear deformation rates of different ground targets are clearly different on the Beiluhe basin. Additionally, there are different time lags between the maximum freezing uplift or thawing subsidence and the maximum or minimum temperature for the different ground target areas. The deformation values of the alpine meadow and floodplain areas are higher compared with the alpine desert and barren areas, and the time lags of the freezing and thawing periods based on the Sentinel-1 results are longest in the alpine desert area, that is, 86 days and 65 days, respectively. Our research has important reference significance for the seasonal dynamic monitoring of different types of seasonal deformation and the extensive investigations of permafrost in Qinghai Tibet Plateau.

The increasing incidence of retrogressive thaw slumps (RTSs) in permafrost regions underscores the need for detailed spatial and temporal analysis using InSAR technology to monitor and predict dynamic changes in the process of RTSs. Nevertheless, current InSAR deformation forecasting methods employing deep learning strategies such as the traditional long short-term memory (LSTM) and recent transformer models encounter difficulties in effectively capturing temporal features. Moreover, they are limited in their ability to directly integrate spatial information. In this paper, an innovative deep learning approach named Spacetimeformer is proposed for predicting medium- and short-term InSAR deformation of RTSs in the Chumar River area. This method employs a transformer architecture with a spatiotemporal attention mechanism, which enhances the long-term prediction capabilities of time series models and dynamic spatial modeling. It is applicable to multivariate InSAR spatiotemporal deformation prediction problems. The findings include a list of 72 RTSs compiled based on derived InSAR deformation maps and Sentinel-2 optical images, of which 64 have an average deformation rate exceeding 10 mm/year, indicating signs of permafrost degradation. The density distribution of the displacement maps predicted by the Spacetimeformer model aligned well with the InSAR deformation maps obtained from the small baseline subset (SBAS) method, with the overall prediction deviation controlled within 20 mm. In addition, the point-scale prediction results were compared with LSTM and transformer models. This study indicates that the Spacetimeformer network achieved good results in predicting the deformation of RTSs, with a root mean square error of 1.249 mm. The Spacetimeformer method for deformation prediction with the spacetime mechanism presented in this study can serve as a general framework for multivariate deformation prediction based on InSAR results. It can also quantitatively assess the spatial deformation characteristics and deformation trends of RTSs.