We report on the development of new optical sensors using molecularly imprinted polymers (MIPs) combined with different materials and explore the novel strategies followed in order to overcome some of the limitations found during the last decade in terms of performance. This review pretends to offer a general overview, mainly focused on the last 3 years, on how the new fabrication procedures enable the synthesis of hybrid materials enhancing not only the recognition ability of the polymer but the optical signal. Introduction describes MIPs as biomimetic recognition elements, their properties and applications, emphasizing on each step of the fabrication/recognition procedure. The state of the art is presented and the change in the publication trend between electrochemical and optical sensor devices is thoroughly discussed according to the new fabrication and micro/nano-structuring techniques paving the way for a new generation of MIP-based optical sensors. We want to offer the reader a different perspective based on the materials science in contrast to other overviews. Different substrates for anchoring MIPs are considered and distributed in different sections according to the dimensionality and the nature of the composite, highlighting the synergetic effect obtained as a result of merging both materials to achieve the final goal.

A sensitive and reliable method using pressurised liquid extraction (PLE) followed by molecularly imprinted solid phase extraction (MISPE) and high performance liquid chromatography with fluorescence detection (HPLC–FLD) has been developed for the analysis of alternariol (AOH) and alternariol monomethyl ether (AME) in tomato samples. Influence of several extraction parameters that affect PLE efficiency were evaluated for the simultaneous extraction of both mycotoxins in the selected samples. AOH and AME were optimally extracted using MeOH/water (25:75, v/v) at 70°C as solvent, a pressure of 1000 psi and a single extraction cycle. The resulting PLE extracts were pre-concentrated by molecularly imprinted solid phase extraction (MISPE) cartridges followed of analysis by HPLC with fluorescence detection (λ_exc = 258, λ_em = 440 nm). The proposed method was applied to the analysis of AOH and AME in fortified tomato samples (20–72 µg· kg–1) with recoveries of 84–97% (RSD < 8%, n = 6) for AOH and 67–91% (RSD < 13%, n = 6) for AME. The detection limit for AOH and AME were 7 and 15 µg· kg^–1, respectively. The ensuing PLE–MISPE–HPLC–FLD method was validated for the analysis of both mycotoxins in tomato samples in accordance with European Commission Decision 2002/657/EC.