Engineering research is undergoing dramatic changes with novel, large-scale research facilities being developed to help reduce the growing economic losses associated with natural disasters. The wall of wind (WOW), at Florida International University (FIU), is such an experimental facility, capable of simulating hurricane winds and wind-driven rain to better understand hurricane effects on buildings and other infrastructure. The WOW has been designated by the national science foundation (NSF) as one of the experimental facilities (EFs) under the natural hazards engineering research infrastructure (NHERI) program, which aims to allow researchers to enable innovations and help prevent natural hazards from becoming societal disasters. The WOW EF’s goal is to facilitate research to improve design practices for structural systems, building envelopes, and lifeline infrastructure. This paper presents an overview of the design and development of the WOW research facility and delineates its capabilities to assess and mitigate the impacts of hurricane wind, rain, and debris on civil infrastructure. Advantages and limitations of the facility are explained. To illustrate the EF’s research capabilities, details and results from three recent case studies related to large-scale and full-scale testing of building components and traffic infrastructure are described.
Hurricane Irma made its first landfall in the continental U.S. at Cudjoe Key in southern Florida on September 10, 2017, with Category 4 winds. Irma made its second landfall later that afternoon on Marco Island on Florida’s Gulf Coast, as a Category 3 storm, weakening further as it moved north. Reconnaissance teams respectively dedicated to the Gulf Coast, Atlantic Coast, and Miami/Florida Keys carried on a first wave of rapid reconnaissance from September 15–20, 2017. A second more exhaustive campaign was then conducted in the Florida Keys on September 22–25, 2017. These investigations employed primarily door-to-door damage assessments to classify buildings and evaluate component damage levels using a Fulcrum mobile smartphone application for data collection in a unified assessment framework feeding into a quality assurance/quality control process. At select locations, unmanned aerial surveys generated aerial imagery, 3D point clouds, and 3D textured meshes. This study presents the geospatial distribution of observed damage, correlated by age of construction, typology, construction materials, and estimated wind speed. Specific case studies highlight common failure modes observed in different construction classes and editions of the Florida Building Code.
Large-scale testing of low-rise buildings or components of tall buildings is essential as it provides more representative information about the realistic wind effects than the typical small scale studies, but as the model size increases, relatively less large-scale turbulence in the upcoming flow can be generated. This results in a turbulence power spectrum lacking low-frequency turbulence content. This deficiency is known to have significant effects on the estimated peak wind loads. To overcome these limitations, the method of Partial Turbulence Simulation (PTS) has been developed recently in the FIU Wall of Wind lab to analytically compensate for the effects of the missing low-frequency content of the spectrum. This method requires post-test analysis procedures and is based on the quasi-steady assumptions. The current study was an effort to enhance that technique by investigating the effect of scaling and the range of applicability of the method by considering the limitations risen from the underlying theory, and to simplify the 2DPTS (includes both in-plane components of the turbulence) by proposing a weighted average method. Investigating the effect of Reynolds number on peak aerodynamic pressures was another objective of the study. The results from five tested building models show as the model size was increased, PTS results showed a better agreement with the available field data from TTU building. Although for the smaller models (i.e., 1:100,1:50) almost a full range of turbulence spectrum was present, the highest peaks observed at full-scale were not reproduced, which apparently was because of the Reynolds number effect. The most accurate results were obtained when the PTS was used in the case with highest Reynolds number, which was the1:6 scale model with a less than 5% blockage and a xLum/bm ratio of 0.78. Besides that, the results showed that the weighted average PTS method can be used in lieu of the 2DPTS approach. So to achieve the most accurate results, a large-scale test followed by a PTS peak estimation method deemed to be the desirable approach which also allows the xLum/bm values much smaller than the ASCE recommended numbers.