Tip clearance flow in axial flow compressor is unavoidable and responsible for pressure losses and noise generation and influences the stability of the compressor. However, necessary flow measurement in the blade tip region is a great challenge due to the small gap width as well as the structure limitation. In this paper, a polyvinylidene fluoride (PVDF) piezoelectric-film sensor array is developed to capture the dynamic pressure field over the blade tip in an axial flow compressor. The PVDF sensor array with 40 evenly distributed sensing points is fabricated directly on a 30 μm thick aluminum-metalized polarized PVDF film through photolithography. Dynamic calibration of the sensor is accomplished using acoustic source as excitation and a microphone as a reference. The test pressure range is up to 3.5 kPa and the sampling frequency is 20 kHz. The sensor presents a high signal-to-noise ratio and good consistency with the reference microphone. Sensitivity, frequency response, linearity, hysteresis, repeatability as well as the influence of temperature are also investigated through the calibration apparatus. The calibration gives credence to the relevance and reliability of this sensor for the application in dynamic pressure field measurement. The sensor is then applied to an actual measurement in a compressor. The output of the PVDF sensor array is also compared with the results of common pressure transducers, and the features of the dynamic pressure filed are discussed. The results indicate that the PVDF sensor array is capable of the dynamic pressure field measurement over the blade tip, and superior to the conventional approaches in installation, spatial resolution, frequency response, and cost. These advantages indicate its potential broad application in pressure measurement, especially for the complex spatial surface or thin-walled structure, such as the blade surface and the thin casing wall of the compressor.
The position of fluid film in journal bearing will change while the journal moving in bearing, which can be named fluid film boundary migration (FFBM). It is usually ignored in the calculation of linear dynamic coefficients. While, the errors brought by this neglection was not ever investigated in detail. In this paper, the influence of FFBM on bearing dynamic coefficients and rotor system dynamic behaviors are investigated. A new perturbation-based model is proposed to take the FFBM into account by modifying the boundary conditions of governing equations. It is then verified by the experimental results and analytical results from previous research. Furthermore, the effects of FFBM on stiffness and damping in two typical journal bearings are investigated. The result indicates that the FFBM has a significant influence on dynamic coefficients of full circular journal bearing but little impact on journal bearing with axial grooves. Moreover, it affects the stiffness and damping more significantly in the cases of large length-to-diameter ratios or small eccentricity ratios in full circle bearing. Finally, the dynamical behavior of a rotor-bearing system with considering the FFBM is also investigated. The result shows that the FFBM of oil film has remarkable influences on the instability threshold and imbalance responses of the rotor system, which should not be ignored. The conclusions obtained in this research are expected to be helpful for the design of full circular journal bearings or rotor-bearing systems.
The reliability and safety of aero-engine are often the decisive factors for the safe and reliable flight of commercial aircraft. Hence, the vibration source location and fault diagnosis of aero-engine are of prime importance to detect faults and carry out fast and effective maintenance in time. However, the vibration signals collected by the sensors arranged on the casing of the