High responsivity, fast response time, ultra-wide detection spectrum are pursuing goals for state-of-art photodetectors. Cd 3 As 2 , as a three-dimensional (3D) Dirac semimetal, has a zero bandgap, high light absorption rate in broad spectral region, and higher mobility than graphene at room temperature. However, photoconductive detectors based Cd 3 As 2 suffer low quantum efficiency due to the absence of high built-in field. Here, a Cd 3 As 2 nanoplate/multilayer MoS 2 heterojunction photodetector was fabricated which achieved a quite high responsivity of 2.7 × 10 3 A W −1 at room temperature. The photodetector exhibits a short response time of in broad spectra region from ultraviolet (365 nm) to short-wavelength-infrared (1550 nm) and reached 65 μ s at 650 nm. This work provides a great potential solution for high-performance photodetector and broadband imaging by combining 3D Dirac semi-metal materials with semiconductor materials.
Tunable complementary split ring resonators (CSRRs) based on monolayer graphene are presented in terahertz regime. By applying different gate voltage, the Fermi level and optical conductivity of monolayer graphene pattern can be changed. Here, we employ a numerical simulation to study the interaction of light with graphene CSRRs. The results indicate that the extinction in transmission becomes stronger, and the resonance frequency presents blue shift with higher Fermi level of the graphene pattern. Three pronounced resonant peaks appear which can be modulated dynamically in the range of 1-2THz and 3-7THz, and realizing dynamic broadband terahertz modulation, the modulation depth exceeds 85% at all three resonant peaks, the highest modulation depth reaches 98.8% at 7.47THz.
We present a p-n-p monolayer graphene photodetector doped with titanium dioxide nanotubes for detecting light from visible to near-infrared (405 to 1310 nm) region. The built-in electric field separates the photo-induced electrons and holes to generate photocurrent without bias voltage, which allows the device to have meager power consumption. Moreover, the detector is very sensitive to the illumination area, and we analyze the reason using the energy band theory. The response time of the detector is about 30 ms. The horizontal p-n-p device is a suitable candidate in zero-bias optoelectronic applications.
Multilayer lithium tantalate thin films have been successfully prepared on Pt/Ti/SiO2/Si(100) substrate using sol-gel and spin-coating method. Polycrystalline perovskite films were obtained through pyrolysis at 400°C and subsequent calcination at various temperatures from 500°C to 700°C for 1h, which were optimized by means of X-ray diffraction, Raman spectroscopy and thermal analysis. The morphology on the top surface and fractured cross section of LT films was observed by a field-emission scanning electron microscope. The 300 nm thick LT film annealed at 650°C exhibited a dielectric constant of 19.8 and a loss tangent of 0.06 at10KHz.