The development of high-performance CO2 capture and separation adsorbents is critical to alleviate the deteriorating environmental issues. Herein, N atom-doped layered graphene (N-MGN) was introduced to form triazine and pyridine as potential CO2 capture and separation adsorbents via regulation of interlayer spacings. Structural analyses showed that accessible surface area of the N-MGN is 2521.72 m2 g−1, the porosity increased from 9.43% to 84.86%. At ultra-low pressure, N-MGN_6.8 have exhibited a high CO2 adsorption capacity of 10.59 mmol/g at 298 K and 0.4 bar. At high pressure, the absolute adsorption capacities of CO2 in N-MGN_17.0 (40.16 mmol g−1) at 7.0 MPa and 298 K are much larger than that of N-doping slit pore. At 298 K and 1.0 bar, the highest selectivity of CO2 over N2 reached up to ~133 in N-MGN_6.8. The research shows that N doping can effectively improve the adsorption and separation capacity of CO2 and N2 in layered graphene, and the interlayer spacing has an important influence on the adsorption capacity of CO2/N2. The adsorption heat and relative concentration curves further confirmed that the layered graphene with an interlayer spacing of 6.8 Å has the best adsorption and separation ability of CO2 and N2 under low pressure. Under high pressure, the layered graphene with the interlayer spacing of 17.0 Å has the best adsorption and separation ability of CO2 and N2.
The Dongying Depression (Bohai Bay Basin, eastern China) was widely filled with evaporite (anhydrite and halite) layers during the Paleogene period, especially the middle of the fourth member of the Shahejie Formation (Es4). Most evaporite layers are interbedded with mudstone strata. The strata of Es4 are divided into three sections, referred to as the upper layers, evaporite layers, and lower layers, respectively. The analysis of elemental concentrations, elemental ratios, and Pr/Ph suggests that the lower layers were deposited in an intermittent saline lake environment within a relatively dry climate. The evaporite layers were formed in a highly saline lake environment, whereas the upper layers were formed in a brackish-saline to fresh-water environment. Organic matter (OM) abundance indices, including total organic carbon (TOC), chloroform extracts, total hydrocarbon content (HC), hydrocarbon generation potential (S1 + S2), and OM type, show that the source rock potential for petroleum generation in the upper layers is best, that in the evaporite layers is fair, and in the lower layers it is poor. Carbon isotopes (δ13C) of hydrocarbons in the evaporite and lower layers were heavier than those in the upper layers. Thermal maturity parameters show that the thermal evolution process of OM in the upper layers was faster where evaporite were present compared with evaporite-free areas, while the thermal evolution of OM in the lower layers was slower in these regions. The high thermal conductivity of evaporites may have accelerated the thermal evolution of source rocks in upper layers and allowed hydrocarbon generation at a shallower burial depth. This resulted in the earlier appearance of the petroleum generation window compared to in evaporite-free areas. Meanwhile, the thermal evolution of OM in the lower layers was restrained, and consequently the hydrocarbon generation window was widened, which implies the potential for petroleum exploration in deep strata under the evaporite sequence. This is a common phenomenon in evaporite-bearing basins, according to previous and present studies.
Most experiments show that gas hydrates are often enriched in C2+ gases relative to the feeding gas source because of fractionation during hydrate crystallization directly from free gases and dissolved gases. However, sediments below and near the base of the gas hydrate stability zone (BGHSZ) in many ocean drilling program (ODP)/International Ocean Discovery Program (IODP) sites are relatively enriched in C2+ hydrocarbon gases, compared with the hydrate-occurring zone above. It is still unclear what kind of process causes the abrupt decreases in C1/C2+ ratios with the depth in headspace gas in sediments around seismic bottom-simulating reflector (BSR) and increasing upward C1/C2 ratios in the hydrate-occurring zone. To test the “dissolution/migration mechanism” and its links to the enrichment of ethane near the BSR and increasing upward C1/C2 ratios in the hydrate-occurring zone, we performed a series of pore-scale experimental observations, simulating the gas dissolution–migration–hydration processes, and investigated the effects of the composition of feeding gases and temperatures on the composition of the hydrate grown under the dissolution–migration mechanism. Hydrates are grown from aqueous fluids supplied by the migration of gases dissolved from the capillary-trapped free gas in a capillary high-pressure optical cell, with different supplying gases (90 mol% CH4 + 10 mol% C2H6, 80 mol% CH4 + 20 mol% C2H6) and a geothermal gradient (temperature from 278.15 to 293.15 K). The gas hydrate structure and composition were determined by quantitative Raman spectroscopy. Our study indicated that (1) under the dissolution–migration–hydration processes, the mole fraction of C2H6 in hydrates is depleted compared with gas sources, which confirms that the dissolution–migration of gases is a mechanism to enrich ethane near the BSR; (2) the proportion of C2H6 in structure I (sI) or structure II (sII) hydrates decreases with decreasing temperature, and decreasing temperature enlarges the difference of diffusion coefficient between methane and ethane and enhances the gas fractionation during migration, which could cause the increase upwardly C1/C2 ratios in the hydrate-occurring zone. A simplified geological model was proposed to explain the variability of hydrate composition with depth in the hydrate-occurring zone and the fractionation of gases near the BSR.
Owing to a stable and porous cage structure, natural gas hydrates can store abundant methane and serve as a potentially natural gas resource. However, the microscopic mechanism of how hydrate crystalline grows has not been fully explored, especially for the structure containing different guest molecules. Hence, we adopt density functional theory (DFT) to investigate the fusion process of structure I hydrates with CH4/C2H6 guest molecules from mono-cages to triple-cages. We find that the volume of guest molecules affects the stabilities of large (51262, L) and small (512, s) cages, which are prone to capture C2H6 and CH4, respectively. Mixed double cages (small cage and large cage) with the mixed guest molecules have the highest stability and fusion energy. The triangular triple cages exhibit superior stability because of the three shared faces, and the triangular mixed triple cages (large-small-large) structure with the mixed guest molecules shows the highest stability and fusion energy in the triple-cage fusion process. These results can provide theoretical insights into the growth mechanism of hydrates with other mono/mixed guest molecules for further development and application of these substances.