Yun Song

Yun Song


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 November 2022 in Sensors
Verified
Journal Article
Open access
PDF file
JWJunjie Wang
Junjie Wang
XWXinjun Wu
Xinjun Wu
YSYun Song
Yun Song
LSLingsi Sun
Lingsi Sun
Nondestructive testing (NDT) is an essential method for assessing structural integrity in the oil and gas industry. Electromagnetic acoustic transducers (EMATs) have been extensively used to detect the wall-thickness reduction of plate-like structures, because they do not require direct contact. The pulse intervals of echoes are used to calculate the remnant thickness of structures. If the width of a single pulse is too large, multiple pulses will be superimposed, making it more difficult to extract the pulse interval. Thus, the width of a single pulse affects the resolution of measurements. This paper investigates the impacts of the backplate position on the pulse width and amplitude of thickness-measurement signals, using EMATs. By means of impedance modeling and measurement, it can be shown that the output impedance of the receiving coil is strongly influenced by the coil-backplate gap. With the increment in the coil-backplate gap, the signal amplitude and damping coefficient increase, while the self-resonant frequency decreases. By means of signal measurements on the specimen, it is shown that the pulse width and the signal amplitude can be significantly influenced by the backplate position. By reducing the coil–backplate gap, the pulse width can be reduced by over 80%, and by increasing the gap, the signal amplitude can be increased by over 300%. These research results can be used to optimize EMAT design, thereby suppressing the superposition of pulse echoes.

19 December 2022 in IEEE Sensors Journal
Verified
Journal Article
Closed access
YSYun Song
Yun Song
XWXinjun Wu
Xinjun Wu
JWJunjie Wang
Junjie Wang
Pulsed eddy current testing (PECT) is widely used to detect corrosion in industrial pipelines with coatings; however, the energy dissipation caused by liftoff limits the detection capability for small-sized pipes, especially the non-ferromagnetic pipes recently installed in various industrial scenarios. Since the magnetic field is not concentrated within non-ferromagnetic pipes due to their low permeability, energy dissipation is particularly large, which makes the PECT challenging. Aiming at such energy dissipation problem, this paper investigates the excitation process of PECT and proposes an optimization method for excitation coils. The proposed optimization aims to increase the incident field intensity, which is then decoupled from the PECT analytical solution, thereby allowing the solution to have only electromagnetic coupling relationship between the excitation coil and the specimen. Theoretical calculations are verified by the finite element method (FEM) simulations, followed by the experimental validation of optimized coils which verified their advantages in enhancing the specimen-related components in signals. Furthermore, PECT performance improvement is also discussed when the average incident field of different surfaces is enhanced. Results show that the coils designed based on the average incident field of modified footprint have good performance.

1 April 2016 in Fusion Engineering and Design
Verified
Journal Article
Closed access
WLW.X. Li
W.X. Li
YSYun Song
Yun Song
MYM.Y. Ye
M.Y. Ye
XPX.B. Peng
X.B. Peng
SWS.T. Wu
S.T. Wu
CZC.C. Zhu
C.C. Zhu

1 July 2021 in Fusion Engineering and Design
Verified
Journal Article
Closed access
RRR. Ragona
R. Ragona
JHJ. Hillairet
J. Hillairet
FDF. Durodié
F. Durodié
CYC. Yu
C. Yu
PMP. Mollard
P. Mollard
YSYun Song
Yun Song