Multi-walled carbon nanotubes (MWCNTs) are an alternative for storage with low cost, eco-friendly, and good performance for both process adsorption and desorption. Herein, a purification procedure of MWCNTs was successfully described and studied by using XRD, TEM, Raman spectroscopy and by means of N₂ adsorption-desorption isotherms using the BET method. The H₂ storage properties at room temperature of the purified carbon nanotubes exposed to gas under pressures between 0.39 and 13.33 kPa was investigated by using the quartz crystal microbalance technique. It was found that the H₂ adsorption capacity is strongly dependent on the morphological and structural characteristics of the carbon nanotubes and their specific surface area. The best sample with specific surface area of 729.4 ± 3 m² g⁻¹ shows a maximum adsorption capacity of 3.46 wt% at 12.79 kPa of H₂ exposure pressure. The adsorption kinetics (t_95%) from the different purified MWCNTs was also investigated as a function of the H₂ exposure pressure as well as the performance of these MWCNTs on the reversibility of the H₂ loading/unloading process when underwent to successive cycles of gas exposure.

Arsenic (As) contamination of water is a serious problem in developing countries. In water streams, arsenic can be as As(V) and As(III), the latter being the most toxic species. In this work, an innovative adsorbent based on CaTiO₃ nanoparticles (CTO) was prepared by the sol-gel technique for the removal of As(III) from aqueous solution. X-ray diffraction of the CTO nanoparticles powders confirmed the CTO phase. Transmission electron microscopy observations indicated an average particle size of 27 nm, while energy dispersive X-ray spectroscopy analysis showed the presence of Ca, Ti, and O in the expected stoichiometric amounts. The surface specific area measured by Brunauer, Emmett, and Teller (BET) isotherm was 43.9 m²/g, whereas the isoelectric point determined by Zeta Potential measurements was at pH 3.5. Batch adsorption experiments were used to study the effect of pH on the equilibrium adsorption of As(III), using an arsenite solution with 15 mg/L as initial concentration. The highest removal was achieved at pH 3, reaching an efficiency of up to 73%, determined by X-ray fluorescence from the residual As(III) in the solution. Time dependent adsorption experiments at different pHs exhibited a pseudo-second order kinetics with an equilibrium adsorption capacity of 11.12 mg/g at pH 3. Moreover, CTO nanoparticles were regenerated and evaluated for four cycles, decreasing their arsenic removal efficiency by 10% without affecting their chemical structure. X-ray photoelectron spectroscopy analysis of the CTO surface after removal experiments, showed that arsenic was present as As(III) and partially oxidized to As(V).

The dielectric properties of CaCu₃Ti₄O₁₂ (CCTO) ceramic prepared by mechanochemical synthesis (MCS) were investigated. The effect on dielectric properties of ball-to-powder weight ratio and milling time was investigated and compared to the behavior of CCTO prepared by conventional solid state reaction (CSSR). CCTO ceramic was partially obtained after 6h of the milling process, while complete transformation was obtained during the sintering step of milled powders. It was shown that the dielectric properties of CCTO processed by MCS are dramatically improved compared with samples prepared by CSSR.