Even if not so ancient, the history of the heat engine efficiency at maximum power expression has been yet turbulent. More than a decade after the publication of the seminal article by Curzon and Ahlborn in 1975, two older works by Chambadal and Novikov were rediscovered, both dating from 1957. Then, some years ago, the name of Yvon arose from a textual reference to this famous relation in a conference article published in 1955. Thanks to a historical study of French-written books not published for a long time, and since never translated into other languages, we bring to light in this paper that this relation was actually first proposed by Henri B. Reitlinger in 1929.
24 April 2018 in International Journal of Engine Research
Water injection is a well-known efficient way to improve the performance of internal combustion engines. Amazingly, most of previous studies have yet only assess this process in an experimental manner, depriving us of an understanding of its specific influence on different operating phases of the engine – density of the aspirated fresh mixture, work required by the compression stroke, and so on – but also of the possibility to predict its effects if set up on an existing engine. Thanks to a theoretical framework specifically developed, and similar to the one commonly used for the analysis of air conditioning systems, we start in this article to untangle in a theoretical manner the different consequences of water injection on internal combustion engines. This first study is specifically focused on the fresh mixture density increase, due to the vaporisation of liquid water in the intake manifold. Results show that in the best scenarios, we cannot expect to increase the amount of fuel finally aspirated into the cylinders by more than 10%. The methodology presented here can be of a precious help for the optimisation of such process if applied to existing or future engines.
Feeding catenaries sometimes induces mechanical problems because of high temperature gradients, particularly for power supply voltage of continues tensions from 750 to 3000 V, contrary to the supplies in alternative tensions used of the order of 25 000 V. One of the major reasons of these problems comes from both high temperatures reached in operating configurations and surrounding conditions. The authors of this study have developed a simple nodal method allowing to estimate the temperatures reached in the volume of the contact wires taking into account the surrounding conditions of thermal exchanges with the atmosphere, so by radiation that convection. The exchanges of the external surface of the wire with the external air are there developed in an original way by taking into account the incidence of the wind with regard to the axis of the catenaries.
20 April 2017 in International Journal of Ambient Energy
The efficient use and understanding of photovoltaic thermal (PVT) modules require accurately evaluating the temperature of their photovoltaic cells. But due to their specific composition, measuring this temperature directly is usually very complicated, if not impossible in practice. In this article, we present an original methodology to estimate the temperature of the cells of a PVT module. In order to do this, we simultaneously conduct experiments on both PVT and PV modules equipped with identical PV cells, and compare their electrical performance. The temperature of the PV module’s back side is measured and used to estimate the temperature of the PV cells. The latter is then combined with the electrical power output difference between PV and PVT modules in order to obtain, through a specifically developed thermal model, the cell temperature of the PVT module. In addition, an experimental comparative analysis of different PVT modules is presented. The methodology and the results are promising but the experimental measurements used are subject to significant uncertainties that impact the accuracy of the estimation. The model uses an innovative approach to estimate the PV cell temperature of PVT modules, and recommendations are provided to optimize experimental data measurement accuracy in order to use this model in the best possible conditions.