Owing to the well-known temperature dependence of photovoltaic (PV) module performance, it is important to correct the performance ratio with respect to temperature. In this study, temperature coefficients given by the manufacturer for three different PV cell technologies are compared with experimentally obtained temperature coefficients for a PV park situated in southern Norway. Three irradiance estimation methods are used to calculate these experimental temperature coefficients. The results show that they can differ significantly from the ones provided in the datasheet of the manufacturer for all three PV systems, but whether the temperature coefficient value increases or decreases depends on the systems and/or the irradiance estimation method. Furthermore, by analyzing nine clear sky days at different times of the year, it is found that the seasonality of the performance ratio can be significantly reduced when employing the experimental temperature coefficient rather than the datasheet temperature coefficient. As such, it may be more relevant to correct the performance ratio with experimental temperature coefficients rather than with the temperature coefficient from the system datasheet, especially for systems that experience large temperature differences. It is also found that the irradiance estimation method can significantly impact the experimental temperature coefficient. This study shows that the choice of irradiance estimation method and temperature coefficient can affect the performance interpretation of solar PV systems and must then be considered carefully.
21 March 2024 in Journal of Solar Energy Engineering
The efficient use and understanding of photovoltaic thermal (PVT) modules require accurately evaluating the temperature of their photovoltaic cells. But due to their specific composition, measuring this temperature directly is usually very complicated, if not impossible in practice. In this article, we present an original methodology to estimate the temperature of the cells of a PVT module. In order to do this, we simultaneously conduct experiments on both PVT and PV modules equipped with identical PV cells, and compare their electrical performance. The temperature of the PV module’s back side is measured and used to estimate the temperature of the PV cells. The latter is then combined with the electrical power output difference between PV and PVT modules in order to obtain, through a specifically developed thermal model, the cell temperature of the PVT module. In addition, an experimental comparative analysis of different PVT modules is presented. The methodology and the results are promising but the experimental measurements used are subject to significant uncertainties that impact the accuracy of the estimation. The model uses an innovative approach to estimate the PV cell temperature of PVT modules, and recommendations are provided to optimize experimental data measurement accuracy in order to use this model in the best possible conditions.
27 October 2026 in Measurement Science and Technology
Critical flow Venturi Nozzles (CFVNs) are expected to play a key role for metrology of gases in the future due to their affordability, reliability and flexibility. While their performance with several inert gases is well documented, there is a lack of experimental data when used with hydrogen. The objective of this work is to estimate the relevance of calibrating CFVNs with air as a surrogate gas for hydrogen, especially at transitional and turbulent flow regimes. Two nozzles with diameters 1 mm and 2 mm are calibrated with both hydrogen gas and air using a primary standard based on a pressure-Volume-Temperature-time (pVTt) system. The results show that the discharge coefficients of the CFVNs for hydrogen and air are within the expanded uncertainty of ±0.3 % (k=2) of the laboratory.
We present the first European intercomparison of primary flow measurement standards with hydrogen-enriched natural gas (up to 20% hydrogen in molar fraction) and natural gas with pressure up to 60 bar and volume flow rates in the range (5 to 160) m3/h. We describe the principles of operation of the primary standards and present the transfer standards, a rotary meter and an ultrasonic meter, used for the intercomparison. In many instances, the overlap between the different laboratories is satisfactory, but the collected results are limited and do not allow us to make advanced conclusions. In addition, we investigate the effect of nitrogen impurities (2% in molar fraction) on the performance of low-pressure gas meters for pure hydrogen using newly developed measurement standards. We present the methods and results of this investigation. We show that nitrogen impurities affect the volume flow measurements of an ultrasonic meter but seem to have little effect on a thermal mass flow meter. This paper explores future opportunities and challenges in international intercomparisons involving hydrogen blends and highlights key issues and solutions with hydrogen gas metering in the presence of impurities.