TEMPO oxidation was conducted as a pretreatment to achieve efficient nanofibrillation of long paper mulberry bast fibers (PMBFs). The pH dependency of nanofibrillation efficiency and the characteristics of the resulting cellulose nanofibrils (CNFs) were investigated. As the pH increased, the negative value of the zeta potential of TEMPO-oxidized fibers increased. The increase in electrostatic repulsion at pH values of greater than 9 prevented the entanglement of long PMBFs, which was a drawback for defibrillation at acidic pH. With increasing pH, the CNF production yield was increased. The crystallinity index of TEMPO-oxidized CNFs from PMBFs was 83.5%, which was higher than that of TEMPO-oxidized CNFs from softwood fibers in the same conditions. The tensile strength of nanopaper from TEMPO-oxidized PMBF CNFs was 110.18 MPa, which was approximately 30% higher than that (84.19 MPa) of the TEMPO-oxidized CNFs from softwood fibers.
Poly(butylene succinate) (PBS)/wood flour (WF) composites with different WF content were prepared by twin-screw extrusion at 160 °C. With increasing WF content, the tensile strength of the PBS/WF composite without polymeric diphenylmethane diisocyante (pMDI) decreased, while that of the composite with pMDI increased. The addition of kraft lignin (KL) deteriorated the tensile properties of the composites both with and without pMDI. The melt flow index (MFI) decreased with increasing WF content, but increased with increasing KL content. The addition of pMDI caused an increase in the melt viscosity of the PBS/WF and PBS/WF/KL composites, resulting in a decrease in the MFI. The composites had lower thermal stability than neat PBS. The exotherms of the PBS/WF (50/50) composite appeared at a higher temperature than that of the neat PBS, but the PBS/WF/KL (50/50/20) composites had similar exotherms as the neat PBS. The addition of KL caused a decrease in the crystallization rate of PBS.
23 March 2019 in Nordic Pulp & Paper Research Journal
Chemical additives are used singly or in combination to impart functionality to hygiene paper (suggested). In particular, in the hygiene paper making process, dry strength agent, wet strength agent, softener, and other are widely used. The effects of chemical additives on the softness components were evaluated. In the case of surface softness, there was no change in MMD according to the addition of dry and wet strength agents. The MMD (mean deviation from the average friction of coefficient) was decreased by adding a softener, which is the purpose of its addition to the hygiene paper making process. The softness and wet strength were improved when the wet strength agent was added before the softener. In addition, lotion treatment was applied to the surface of tissue paper. The surface softness component of non-silicone-based lotion was similar or improved, which may overcome the problems of silicon-based lotion.