We propose and analyze a scalable microring-based Clos switch fabric architecture constructed with switch-and-select switching stages. A silicon 4×4 building block that was designed and fabricated through AIM Photonics is used for the proof-of-principle demonstration of a 16×16 Clos switch fabric. By fully blocking the first-order crosstalk, the 4×4 device is measured to show a crosstalk ratio in the range of -57 dB to -48.5 dB, enabling better than -39 dB crosstalk for the 16×16 switch. Our study shows that the three-stage Clos design enables up to a factor of 4 in the reduction of the number of switching cells compared to single-stage switch-and-select fabrics. We further explore the design space for both first-order and second-order switching elements using the foundry-validated parameters and how these factors impact the performance and scalability of the three-stage Clos switch. A detailed power penalty map is drawn for Clos switch fabrics with various scales, which reveals that the ultimate key limiting factor is the shuffle insertion loss. An optimized 32-port Clos switch fabric using foundry-enabled parameters is shown to have a less than 10 dB power penalty.
We demonstrate the first multi-stage 8×8 silicon photonic switch with switching elements based on dual add-drop microrings with a compact footprint of 4 $\text{mm}^2$ . This device leverages co-design of the switch architecture and the switching elements with a well-balanced set of performance metrics. The switching elements are designed to have a 3-dB optical passband of 165 GHz, exhibiting off- and on-resonance losses of 0.67 dB and 2 dB, respectively. Full characterization of all switch paths shows an end-to-end on-chip loss between 4.4 and 9.6 dB, with worst-case crosstalk leakage averaged at -16 dB. Owing to the efficient doped waveguide thermo-optic phase shifters, the device features a tuning efficiency of 48.85 GHz/mW. The reconfiguration time of the switch fabric is measured to be 1.2 μs and 0.5 μs at the rise and fall edge, respectively. The dual-microring switching element together with the multi-stage architecture preserves an end-to-end passband over 55 GHz. We validate the switch performance with optical paths of varying numbers of on- and off-resonance switching elements – less than 2 dB power penalties are obtained for all data routings at 32 Gbps.
Optical transmitters typically require electrical pre-amplification using driver amplifiers to optimize the optical modulation depth. To enhance the detection sensitivity and optimize the overall link budget, equalization is required to compensate for undesired signal distortion induced by the transmitter. In this paper, we propose and demonstrate a novel optical equalization scheme using a silicon photonic micro-ring resonator (MRR)-based switching circuit for mitigating driver-amplifier-induced pulsewidth distortion. The switching circuit simultaneously functions as a spatial optical switch as well as a two-stage optical bandpass filter for optical equalization. The experimental results indicate a 4.5-dB detection sensitivity enhancement at a data rate of 12.5 Gbits/s. The proposed approach is robust to different levels of pulsewidth distortion without additional signal processing, and has possibilities to support higher data rates by adjusting the MRR parameters.