Solving a short mileage and a long charging time is indispensable in putting electrical vehicles (EVs) on the full-scale market. A dynamic wireless power transfer (WPT) system is one of the effective solutions, because it can feed electric power to moving EVs. This paper proposes a dynamic WPT system consisting of several stationary ground-side (primary) coils and a moving vehicle-side (secondary) coil. This system is characterized by the use of the common vehicle-side coil to both dynamic and stationary WPT situations. Theoretical analysis concludes that the dynamic WPT system resulting from a stationary WPT system is the same in equivalent circuit as the stationary system. The dynamic WPT system employs solenoid coils that are superior to circular coils in terms of misalignment and flux-distribution performance. A downscaled dynamic WPT system rated at 3 kW is designed, constructed, and tested to verify the principles of operation, and the capability of continuous power transfer.
In this study, a novel system named the third-generation wireless in-wheel motor (WIWM-3), which has a dynamic wireless power transfer (DWPT) system, is developed. It can extend the cruise range, which is one of the key specifications of electric vehicles. DWPT also reduces CO2 emission as the driving resistance is reduced due to light weight of the batteries. In this study, CO2 emission by an internal combustion vehicle, a long range drivable electric vehicle with the same cruise range, and an electric vehicle with WIWM-3 equipped with the DWPT system are analyzed using actual measurement data and calculated data based on actual measurement or specification data. A WPT system with WIWM-3 achieves 92.5% DC-to-DC efficiency as indicated by an actual measurement at the nominal position. Thus, the electric vehicle with DWPT can reduce up to 62% of CO2 emission in internal combustion vehicles, and the long-range drivable vehicle emits 17% more CO2 than the electric vehicle with DWPT. Moreover, it is expected that by 2050, electric vehicles with DWPT will reduce CO2 emissions from internal combustion vehicles by 95% in Japan. DWPT systems make electric vehicles more sustainable and, hence, more acceptable for consumers.
12 July 2023 in IEEE Transactions on Power Electronics
Self-inductance variations caused by component tolerance and aging decrease the efficiency of wireless power transfer (WPT) systems. This paper deals with this issue by compensating for the self-inductance variations using pulsewidth modulation controlled switched capacitors. Previous methods relied on wireless communication between the transmitter (Tx) and receiver (Rx) to control the variable capacitors, which is not a feasible approach when considering practical constraints. This paper proposes a control scheme in which the switched capacitors are controlled simultaneously by separate closed-loops on the Tx and Rx sides, thus eliminating wireless communication. The control scheme is based on a unique condition for perfect resonance derived by focusing on the output power of the WPT circuit. This paper also points out the necessity to compensate for the self-inductance variations of both the Tx and Rx coils to achieve maximum AC/AC efficiency in battery charging applications. Furthermore, the proposed control scheme incorporates the soft switching condition of the inverter to improve the DC/DC efficiency. Experimental results of a 1-kW prototype show that the switched capacitors can flexibly adapt to the self-inductance variations and improve the AC/AC efficiency and DC/DC efficiency by up to 3.04% and 8.63%, respectively.
13 December 2017 in IEEE Transactions on Intelligent Transportation Systems
This paper proposes a new approach for optimal allocation of wireless power transfer system (WPTSys) from a viewpoint of optimal control problem (OCP) for autonomous driving electric vehicles (EVs). These EVs are assumed to accurately follow a pre-determined speed profile. By transformation of the nonlinear optimization problem for optimal allocation of WPTSys to an OCP, well-known methods guaranteeing the global optimality of solution for the OCP are applied, such as Pontryagin's maximum principle or dynamic programming. Therefore, the global optimal solution of the allocation problem of WPTSys can be obtained. In addition, we consider a practical situation of EV operation from a probability point of view, where many EVs are operated with different initial battery state-of-charge.
22 June 2023 in IEEE Journal of Emerging and Selected Topics in Industrial Electronics
The paper proposes a method to improve the tran- sient characteristics of current overshoot and oscillation at the start of power transmission for a dynamic wireless power transfer system. The system is important to reduce the settling time as short as possible without current overshoots for a stable power supply. However, conventional methods to suppress current overshoot have a slow response on the secondary side. This paper proposes the superposition of primary and secondary responses. The proposed method controls the secondary voltage by comparing the steady-state current with the current value on the secondary side. The method can effectively suppress the oscillations in the transient response by applying the secondary voltage at the appropriate timing. This paper also studied the ro- bustness of constraints based on model analysis and experimental verification. In the experiments, the proposed method reduces the current overshoot and the settling time of the secondary current, and maximizes the receiving energy.
1 November 2024 in IEEJ Journal of Industry Applications
A wireless power transfer system has been widely developed for various applications. A parity-time symmetry WPT (PT-WPT) technology is currently attracting attention for ensuring the robustness of the coupling coefficient changes. The system uses self-oscillation, and therefore, the system does not determine the oscillation frequency. This paper proposes a PT-WPT system using asymmetric coils and a digital separate-oscillation controller. The impedance analysis concludes that the operation frequency, power, and efficiency are constant with the coupling coefficient changes and the same as in a coupled mode theory. Further, the analysis derives the phase and amplitude of the voltage and current, especially the output current. A perturbation and observer method is installed to achieve zero phase between the input voltage and current changing operating frequency. The asymmetric coil WPT system and the digital separate-oscillation controller are designed, constructed, and tested to verify the principles of operations. The experimental results are in good agreement with the calculated values. The proposed method controls the stability and unity power factor. The converged time of the proposed system is 15 ms. The output power and efficiency are 202.4 W and 90.75% and these values are constant varying the coupling coefficient.