A new tetragonal BaCN2 polymorph was obtained via a simple nitridation reaction of BaCO2, and the Eu doped product showed a red emission with an extremely wide range of red-shift of the emission wavelength with decreasing temperature.
Solid phase sintering of dielectric oxynitride perovskites above 1000 °C is accompanied by their decomposition. Post-ammonolysis is required to recover their stoichiometric nitrogen content and dielectric properties. In the present work, the oxynitride perovskite SrTaO2N was sintered with a BaCN2 flux at approximately 900 °C avoiding its thermal decomposition. The resulting solid product with a relative density of 68.9% showed relative dielectric constants in the range from 68 to 90 with loss values less than 0.11, without the post-ammonolysis. The interior of the solids contained rectangular Sr1−xBaxTaO2N crystals for which 0.04 ≤ x ≤ 0.23 reflecting their euhedral form. These crystals were grown in molten BaCN2 from 20 to 100 times larger than the original SrTaO2N particles and had a maximum grain size of 3.7 μm. The Sr1−xBaxTaO2N precipitated on the surfaces of the residual SrTaO2N crystals that had partially dissolved in the BaCN2 flux. A compositional gradient from barium-rich to strontium-rich was observed in a single crystal of the product on going from the exterior to the interior. This is the first-ever report of the preliminary liquid phase sintering and crystal growth of a dielectric oxynitride perovskite using a molten metal cyanamide.
Electron emission characteristics of carbon nanotube cathodes with and without reactive ion etching (RIE) followed by KrF laser irradiation were investigated. The emission characteristics of samples without RIE process, such as emission current density, turn-on field, and emission pattern, strongly depend on the laser power density, which is caused by a photon process at low laser power densities of and a thermal ablation at high power densities of . The emission characteristics of samples with RIE, however, show little change when the laser power density is varied. Surface morphologies of CNT cathodes with RIE process show little change by laser treatment compared to the case of CNT cathodes without RIE process.
1 March 2000 in Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
It has been shown by previous work [M. Takai et al., J. Vac. Sci. Technol. B 13, 441 (1995)] that field emission of silicon emitters can be enhanced by anodization forming a layer of porous silicon. Typically, an increase of the emission current of a factor of 10 could be measured. The effect of enhanced emission is usually attributed to nanometer sized silicon rods on the surface, leading to local peaks of electrical field strength [E. C. Boswell et al., J. Vac. Sci. Technol. B 14, 1895 (1996)]. The possibility of a sharpening of the tip has also been discussed. The theoretical part of the above-mentioned investigations has been qualitative in nature. In this work, a quantitative discussion of these effects is performed. For this purpose, a finite element (FEM) model has been constructed on the basis of the test structures. Since the performance of FEM degrades in the vicinity of singularities, such as sharp tips analytical solutions have been employed in order to check the accuracy of the numerical solution and to discuss the behavior of the electrical field close to “rough” surfaces.