Covalent organic frameworks (COF) have been gathering much attention because the shapes, sizes, and chemical functions of their nanostructured pores can be arbitrarily controlled by designing the organic precursors. We fabricated cm-sized free-standing COF films with the thickness of 50–100 nm by an alternating vacuum deposition polymerization method. Precise adjustment of the stoichiometry by digitally controlled deposition was essential for producing the robust free-standing COF films. High-resolution electron microscopy revealed 3 nm pore structures, which correspond to the atomic structure of the COF. Small angle X-ray diffraction shows the existence of a similar periodicity. The CO2/N2 gas phase separation properties were evaluated from 103–105 Pa, and the parameters for each molecular permeation were determined. Based on the detailed analysis, it was found that the selectivity comes from the greater sorption affinity of CO2 to the COF compared to N2, which is consistent with the quantum chemical calculation. Since the vapor phase method can be used to coat various shaped templates, our method provides a new option for fabrication of neat COF membranes with various structures and their applications for the separation membrane.
Thermal switches, which electrically turn heat flow on and off, have attracted attention as thermal management devices. Electrochemical reduction/oxidation switches the thermal conductivity (κ) of active metal oxide films. The performance of the previously proposed electrochemical thermal switches is low; the on/off κ-ratio is mostly less than 5, and the κ-switching width is less than 5 watts per meter kelvin. We used a CeO 2 thin film as the active layer deposited on a solid electrolyte YSZ substrate. When the CeO 2 thin film was reduced once (off-state) and then oxidized (on-state), κ was about 2.2 watts per meter kelvin in the most reduced state, and κ increased with oxidation to 12.5 watts per meter kelvin (on-state). This reduction (off-state)/oxidation (on-state) cycle was repeated 100 times, and the on/off κ-ratio was 5.8, and the κ-switching width was 10.3 watts per meter kelvin. The CeO 2 -based solid-state electrochemical thermal switches would be potential devices for thermal shutters and thermal displays.