Knowledge about laminar–turbulent transition on operating multi megawatt wind turbine (WT) blades needs sophisticated equipment like hot films or microphone arrays. Contrarily, thermographic pictures can easily be taken from the ground, and temperature differences indicate different states of the boundary layer. Accuracy, however, is still an open question, so that an aerodynamic glove, known from experimental research on airplanes, was used to classify the boundary-layer state of a 2 megawatt WT blade operating in the northern part of Schleswig-Holstein, Germany. State-of-the-art equipment for measuring static surface pressure was used for monitoring lift distribution. To distinguish the laminar and turbulent parts of the boundary layer (suction side only), 48 microphones were applied together with ground-based thermographic cameras from two teams. Additionally, an optical camera mounted on the hub was used to survey vibrations. During start-up (SU) (from 0 to 9 rpm), extended but irregularly shaped regions of a laminar-boundary layer were observed that had the same extension measured both with microphones and thermography. When an approximately constant rotor rotation (9 rpm corresponding to approximately 6 m/s wind speed) was achieved, flow transition was visible at the expected position of 40% chord length on the rotor blade, which was fouled with dense turbulent wedges, and an almost complete turbulent state on the glove was detected. In all observations, quantitative determination of flow-transition positions from thermography and microphones agreed well within their accuracy of less than 1%.
In a combined approach of extensive measurement and accompanying simulation a wind turbine blade used in the 1.5 MW class was investigated for improvement of aerodynamic properties and especially the energy yield. One blade was dismantled and its geometry was locally measured by a specially designed laser scanning-system. From this geometry data set five 2D wind tunnel models were manufactured and measured in the wind tunnel of Deutsche Wind Guard Engineering GmbH at Bremerhaven, Germany. In addition, extensive CFD investigations were performed to investigate the usefulness of so-called aerodynamic devices like vortex generators, Gurney flaps and others for improving energy yield. As a result it could be shown that the aerodynamic efficiency of the manufactured blades - if measured in terms of lift-to-drag ratio - is at a high level but still can be further improved. 3D CFD investigations were able to show the influence of Gurney flaps and boundary layer fences and their interactions.