The resilient modulus of the subgrade is an important material parameter for pavement design. This paper presents an unconfined laboratory testing method for resilient modulus under repeated freeze-thaw cycles. The method was validated by a standard testing method. Specimens of three types of fine-grained subgrade soil with a low plasticity index with five different levels of moisture were tested by the proposed testing procedure. The size of the specimen was 50 mm in diameter and 50 mm in height to more accurately illustrate the freeze-thaw conditions. The numbers of freeze-thaw cycles were designated 0, 3, 6, 9 and 12. The results indicate that all the soils exhibited a substantially reduced resilient modulus after the first three freeze-thaw cycles. After six freeze-thaw cycles, the decrease in the resilient modulus was not obvious. The resilient modulus due to six cycles was suggested for use in pavement design. The reduction coefficients for the freeze-thaw effect were also recommended. These reduction coefficients are 0.5–0.6 for specimens with optimum moisture content and 0.7–0.8 for specimens under dry conditions.
1 November 2003 in Tellus B: Chemical and Physical Meteorology
Tropospheric ozone (O3) profiles over the east China coast at LinAn (30.30°N, 119.75°E) were measured by electrochemical concentration cell ozonesondes in the spring of 2001. The measurement revealed that extremely high O3 with mixing ratios up to 1200 ppbv sometimes penetrated deeply into 8.5-16 km above sea level as a result of lowering of the tropopause across the East Asia strong subtropical jet stream. In addition, high O3 in the 75-150 ppbv range penetrated into the upper and middle troposphere following the extreme O3 regimes and caused an overall high O3 mixing ratio in these regions. The occurrence of the high O3 regimes followed the propagation of dry air with low relative humidity and high potential vorticity suggesting that the O3 is of stratospheric origin, High O3 episodes with O3 mixing ratios in the 75-100 ppbv range were observed in the lower troposphere and especially in the boundary layer. Trajectory analysis suggested that the O3-rich air masses had passed through the industrialized and urbanized zones of the Pearl River Delta region of south China, northeast China coast and Yangtze River Delta region of east China. The O3 is probably of anthropogenic origin resulting from photochemical formation from pollutants emitted from these regions. Our analysis thus revealed that over the east China coast at LinAn, stratospheric O3 is still the predominant source of O3 in the middle and upper troposphere, while anthropogenic sources caused a high O3 pollution episode in the boundary layer.Department of Civil and Environmental Engineerin
Polypropylene fiber‐reinforced concrete (PFRC) is a cement‐based composite material with short‐cut fibers which has been utilized to provide multidimensional reinforcement and enhance toughness of concrete. However, this improvement is closely related to the microstructural morphology of the concrete. A nondestructive technique using X‐ray computed tomography (CT) was therefore used to grasp the microscopic texture of PFRC samples. The results showed that the orientation of microcracks, which appear in the interfacial transition zone, are along the surface of the coarse aggregate. The range of distribution of fibers is proportional to fiber volume fraction. The coarse aggregate influence distribution and orientation of polypropylene fibers whose shape are mainly fold line and curve. The dispersion of pores with small volume is uniform, and the distance between the pores with larger volume is short. The proportion of pores with the diameter in the range 0∼199 μm exceeds 70%, of which the sum of volume exceeds a half of total volume with the amount being about 1% of total amount.