A wireless vacuum sensor based on the Pirani principle and Surface Acoustic Waves (SAW) has been designed, simulated and manufactured. The sensing unit is a heat conductivity gauge based on a passive SAW temperature sensor. The required heating energy is applied to the sensor by means of inductive coupling whereas the measurement signal is sent via a ceramic antenna. The sensor is a compact polymer cube containing all the units and operating completely wireless. Simulation was used to design and optimize the behavior of the sensor in vacuum and to predict the performances of the sensor. It was followed by the manufacturing and the assembly of a prototype. This communication presents the design, the simulation results and the manufacturing steps of the prototype.
A prototype of a wireless vacuum microsensor combining the Pirani principle and surface acoustic waves (SAW) with extended range and sensitivity was designed, modelled, manufactured and characterised under different conditions. The main components of the prototype are a sensing SAW chip, a heating coil and an interrogation antenna. All the components were assembled on a 15 mm × 11 mm × 3 mm printed circuit board (PCB). The behaviour of the PCB was characterised under ambient conditions and in vacuum. The quality of the SAW interrogation signal, the frequency shift and the received current of the coil were measured for different configurations. Pressures between 0.9 and 100,000 Pa were detected with sensitivities between 2.8 GHz/Pa at 0.9 Pa and 1 Hz/Pa close to atmospheric pressure. This experiment allowed us to determine the optimal operating conditions of the sensor and the integration conditions inside a vacuum chamber in addition to obtaining a pressure-dependent signal.