Reliability engineering plays an important role in the design, manufacture, maintenance, and replacement of industrial products. Over the last few decades, accelerated degradation testing (ADT) has been largely utilized to shorten test durations, reduce the samples needed, and provide sufficient degradation data to ensure the effective reliability assessment of the concerned products. Meanwhile, performance degradation modeling has been recognized as an essential approach to help researchers and producers understand the health conditions of the deteriorating systems. However, the diversity in reliability tests, degradation models, and statistical analysis techniques has increased the difficulty in selecting appropriate reliability assessment methods in specific scenarios. Besides, there are no systematic reviews focused on modeling and analysis of performance degradation data. Therefore, this paper aims to (1) present ADT fundamentals, including the basic theory, ADT methods, accelerated stress variables, type of acceleration models, as well as ADT optimization, (2) comprehensively review current states and future challenges in degradation modeling, (3) discuss the problem of model mis-specification and compare different approaches for parameter estimation, (4) highlight future opportunities and possible directions deserving further research.
30 September 2019 in Journal of Applied Polymer Science
This paper proposes a model predictive control (MPC) scheme based on linear parameter variation to enhance the damping control of speed-dependent active suspensions. The controller is developed by introducing a speed-dependent term, specifically front- and rear-wheel time delays, to the half-car model using the Padé approximation. Subsequently, the model is augmented with time-varying parameter dependence. An adaptive Kalman filter based on variance matching is employed to estimate system states affected by imprecise sensor measurement noise. Finally, a set of explicit control laws incorporating road preview information and available vehicle speed are determined offline using multi-parameter linear programming (mp-LP), simplifying online implementation to searching for optimal solutions in a lookup table. Simulation results demonstrate a significant improvement in active suspension control under changing vehicle speeds compared to passive control.
5 March 2023 in Mechanical Systems and Signal Processing
Smart structures such as damping adjustable dampers made of magnetorheological (MR) fluid can be used to attenuate vibration transmission in vehicle seat suspension. The main research content of this paper is the nonlinearity and hysteresis characteristics of the MR damper. A hysteretic model considering both excitation characteristics and input current is proposed to fit the damper force‐velocity curve for the MR damper under different conditions. Multifactor sensitivity analysis based on the neural network method is used to obtain importance parameters of the hyperbolic tangent model. In order to demonstrate the fitting precision of the different models, the shuffled frog‐leaping algorithm (SFLA) is employed to identify the parameters of MR damper models. The research results indicate that the modified model can not only describe the nonlinear hysteretic behavior of the MR damper more accurately in fixed conditions, compared with the original model, but also meet the fitting precision under a wide range of magnitudes of control current and excitation conditions (frequency and amplitude). The method of parameter sensitivity analysis and identification can also be used to modify other nonlinear dynamic models.