We investigated the effect of top contact interface and microstructural characteristics of the insulating layers on resistive switching behaviors by fabricating and characterizing the HfO 2 /ZnO bilayer heterostructures. Different thickness of ZnO underlying layer and different deposition temperatures of the upper HfO 2 layer were designed to analyze the intrinsic contribution of the crystalline microstructure of the insulating bilayer. Pt and Ti top electrodes were used to demonstrate the extrinsic contribution of the interface configuration. It was observed that all devices show bipolar RS characteristics. Unlike the device composed of Pt/HfO 2 /ZnO/Pt that exhibit an abrupt switching, a gradually continuous switching in the reset process was identified in the device composed of Ti/HfO 2 /ZnO/Pt. Interfacial charge migration process/characteristic plays a key role in the RS process as well as its conduction mechanism. The RS performance of the former is significantly better than that of the latter, including much lower reset voltage, two orders of magnitude larger OFF/ON ratio and HRS resistance. In addition, as compared to the intrinsic contribution arising from the microstructure of the HfO 2 /ZnO bilayer to the RS performances and current transport mechanism, the extrinsic effect contributed from the electrode characteristics (and its interface) is dominant.
Front surface texturing is a common method used to improve the optical performance of photovoltaic devices. However, traditional texturing techniques may be challenging in some cases, such as when dealing with ultra-thin substrates. Textured polymer films on such devices would be an alternative approach. This paper reports a study of NOA81 thin films with a bionic lotus leaf surface structure on monocrystalline silicon solar cells. Inspired by the surface structure of natural lotus leaves, we successfully prepared a bionic lotus leaf microstructure film on the surface of solar cells based on NOA81 using polydimethylsiloxane (PDMS) polymer and nanoimprinting methods. Scanning electron microscopy (SEM) images showed that the surface structure of the NOA81 thin film was the same as that of natural lotus leaves. A UV-Vis spectrophotometer with an integrating sphere was used to measure the reflectance of the textured NOA81 film on the silicon wafer. Results showed that the textured NOA81 film could effectively reduce the reflectance of the silicon wafer surface. We also used finite-difference time-domain (FDTD) simulation to verify this conclusion further. Finally, the I-V characteristics of the prepared solar cells with the textured NOA81 film were investigated, and the highest photovoltaic efficiency was measured to be about 16.07%, effectively improving the photoelectric conversion efficiency. In addition, the film with textured NOA81 can be used as a protective film for monocrystalline silicon solar cells.