In this paper, a unusual switching technique is implemented using a fuzzy logic approach. The proposed technique simplifies the conventional method by eliminating the traditional logic gate design. The fuzzy logic pulse generator acts as a look-up table as well as a pulse generator. Based on the modulation index as input, controlled membership functions (MFs) and rules of the fuzzy logic controller (FLC) opens various possibilities in producing pulses directly. The proposed technique is evaluated on the cascaded multilevel inverter with symmetric and asymmetric operations using selective harmonic elimination pulse width modulation (SHE-PWM). MFs are designed based on the pre-calculated firing conditions for different modulation index values. The hardware verification is carried out to support the proposed switching technique.
29 May 2020 in IEEE Transactions on Circuits and Systems II: Express Briefs
Nowadays, output voltage boosting gain property along with curtailment in the circuit voltage stress, and component count are considered as the essential topological features for the new multilevel inverter (MLI) circuits. Recognizing the above, a hybrid nine-level inverter topology (HNIT) for DC-AC conversion is proposed in this work. Each phase of the HNIT is designed with only eight semiconductor switches, one diode, and two electrolytic capacitors. Herein, series-parallel and conventional-series techniques are utilized effectively to balance the capacitor voltages. Further, cost and quantitative comparisons are carried among the state-of-art circuits to highlight the supremacy of proposed circuit. Subsequently, the performance of HNIT is verified experimentally with the fundamental switching PWM technique at different load conditions.
31 January 2020 in International Journal of Circuit Theory and Applications
In this study, a novel nine‐level modified T‐type multilevel inverter (MT‐MLI) with a simple capacitor balancing technique is proposed. The proposed MT‐MLI circuit can generate higher levels with a single DC source and the minimum number of switching components. Each phase of the proposed topology contains ten switches and one flying capacitor (FC). The DC source voltage is divided into two parts with the help of capacitors. Phase disposition‐sine pulse‐width modulation technique is employed to regulate the DC‐link capacitors and FC voltages. To reduce the control complexity of FC‐based circuits, quarter‐cycle selector is introduced to control the FC voltage within the given half fundamental cycle using redundant states, so an external capacitor charging setup is not required. Furthermore, to highlight the potential merits of the proposed MT‐MLI, the comparison is made among state‐of‐the‐art MLIs. Simulation verification of the MT‐MLI is done using MATLAB/Simulink, and then hardware verifications are done using the laboratory prototype setup with Opal‐RT controller. Finally, adequate results are presented to validate the proposed MT‐MLI.